Read Sony DSC-RX100M4 (serv.man2) Service Manual online
4.
Attach the DC Motor Worm Assy and tighten two screws. And install the 1st/2nd/3rd group assy to the Stationary
Tube matching the phase marks as shown in the figure.
Tube matching the phase marks as shown in the figure.
Note
• When installing this assy, confirm that the convex parts of the 3 Group Frame Block Assy, 1 Group Frame
Block Assy and the Cam Tube are shown below.
• Confirm that the straight key of the 3 Group Frame Block Assy is fit in the groove of the Stationary Tub. If
the straight key is not fit in the groove, repeat these steps from step 1.
1st/2nd/3rd group assy
3 Group Frame Block Assy
Straight Tube Block Assy
Cam Tube
Convex parts
Gear end
Straight Tube Block Assy
Stationary Tube
Fit to groove
DC Motor
Worm Assy
Worm Assy
5.
Install the Lubricating Block Assy (B)* and turn it clockwise to the maximum extent.
*) Use a Lubricating Block Assy (B) that was not installed in the unit.
*) Use a Lubricating Block Assy (B) that was not installed in the unit.
Lubricating Block Assy (B)
6.
Pass the two flexible boards through the holes in the Stationary Tube.
Stationary Tube
SS flexible board
SH flexible board
DSC-RX100M4
4-31
Click on the first or last page to see other DSC-RX100M4 (serv.man2) service manuals if exist.