DSC-RX1, DSC-RX1R (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 27

DSC-RX1/RX1R_L2

3-1

Assembly-1: Notes on Assembling the IM Imager Unit and Lens 

Block.

1

2

3

1

2

2

2

2

4

2

3

2

1

3

IM Imager Unit

Seal Frame

Glossy surface
(eyepiece side)

Rear Tube

Screw tightening sequence when
assembling the IM Imager Unit.

2

3

3

2

2

4

3

1

Lens

Screw tightening sequence when
assembling the Lens.

Screw tightening sequence when
assembling the Rear Tube.

Install the Seal Frame facing the glossy surface
side to the IM Imager Unit.

Rear Tube

Number

Number

Data Carry QR Seal

Lens

Lens

Data Carry QR Seal

JK-1002 Flexible Board

When using a new lens, remove the Data Carry QR Seal from
the lens and stick it to the JK-1002 Flexible Board at the location
shown in the figure below.

When using a new lens, confirm that the number described in the seal
on the lens is equal to the number described in the seal on the Rear
Tube, and then install the lens to the main body.

Assembly-2: Notes on Assembling the II-2001 Flexible Board.

II Flexible Retainer

II-2001Flexible Board

Boss

Claw

Claws

After the II Flexible Retainer has been installed, confirm that
the II-2001Flexible Board is engaged with the five claws and
the one boss.

Assembly-3: Notes on Assembling the E Dial and M Dial.

Steel Ball

Apply the certain grease
(0.04g)

Apply the certain
grease (0.04g)

3

 Apply the certain grease that comes with BALL, STEEL ASSY 

(SERVICE) (A-1911-422-A) to the Steel Ball.
4

 Install the E Dial Ball Spring and the Steel Ball Assy, and then

install the E Dial fitting it with the D Cut portion. Then tighten
a screw.

1

 Apply the certain grease that comes with BALL, STEEL ASSY 

(SERVICE) (A-1911-422-A) to the Steel Balls.
2

 Install the two M Dial Ball Springs and the two Ball Steels,

and then install the M Dial fitting it with the D Cut portion.
Then tighten a screw.

E Dial Ball Spring

E Dial

D Cut portion

D Cut portion

M Dial Ball
Springs

M Dial

Steel Balls

D Cut portion

D Cut portion

Assembly-4: Notes on Assembling the Control Switch Block.

Control Switch Block

Lever

Install the Control Switch Block while pulling the Shutter
Button Assy lever and the Control Switch Block lever in the
direction of arrow.

Shutter Button Assy

Assembly-5: How to fold the II-2001 Flexible Board.

II-2001
Flexible Board

Adhesive
Parts

Valley
fold

Valley
fold

Mountain
fold

Mountain
fold

Adhesive
Part

Fold dotted line parts of the II-2001 Flexible Board
as shown in figure.

Valley fold