DSC-P30, DSC-P50 (serv.man3) - Sony Digital Camera Service Manual (repair manual). Page 9

Read Sony DSC-P30 / DSC-P50 (serv.man3) Service Manual online

1-3
Getting
 sta
rt
ed
11
Open the battery cover with the battery cover side facing upward and remove the 
batteries. Be careful not to drop the batteries when removing them.
Power save mode
When operating the camera with batteries, set POWER SAVE in the SET UP screen 
to ON to extend the battery life. The factory setting is ON (page 70).
See page 88 for more information on power save mode.
Auto power-off function
If you do not operate the camera for about three minutes during recording or 
playback, the camera turns off automatically to prevent wearing down the battery. To 
use the camera again, press the POWER button to turn on the camera again. The auto 
power-off function only operates when the camera is operating using a battery pack. 
The auto power-off also will not operate when playing back moving images or 
playing back a slide show (page 60), or when a connector is plugged into the USB 
jack or the DC IN jack.
* What is “InfoLITHIUM”?
“InfoLITHIUM” is a lithium ion battery pack which can exchange information such as battery 
consumption with compatible video equipment. This unit is compatible with the 
“InfoLITHIUM” battery pack (S series). “InfoLITHIUM” S series battery packs have the 
 mark. “InfoLITHIUM” is a trademark of Sony Corporation.
NP-FS11 battery pack (not supplied)
When you record images in an extremely cold location or using the LCD screen, the 
operating time becomes short. When using the camera in an extremely cold location, 
place the battery pack in your pocket or other place to keep it warm, then insert the 
battery pack into the camera just before recording. When using a pocket heater, take 
care not to let the heater directly contact the battery.
2
Install the batteries.
Insert the two size AA batteries with the 3 and # ends facing as illustrated. Be 
careful not to insert the batteries facing the wrong way.
3
Close the battery cover.
Pressing the batteries with the cover, close the cover firmly until it clicks into 
place.
To remove the batteries
12
You cannot charge the battery pack while your camera is turned on. Be sure to turn 
off your camera.
 
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camera.
Battery remaining indicator 
When using an optional “InfoLITHIUM” battery pack, the LCD screen on the 
camera shows the remaining time for which you can still record or play back images. 
This indication may not be entirely accurate depending on the conditions of use and 
the operating environment.
Charging of 10°C to 30°C (50°F to 86°F) circumstances is recommended.
When using size AA alkaline batteries, the remaining time is not shown.
Note
When you turn the LCD screen on and off, it takes about one minute for the correct battery 
remaining time to appear. 
Charging the battery pack (not supplied)
1
Insert the battery pack into your camera.
2
Open the DC IN jack cover and connect the DC connecting cable to 
the DC IN jack of your camera with the 
v
 mark facing up.
3
Connect the power cord (mains lead) to the AC power adaptor (not 
supplied) and then to a wall outlet (mains). 
The  /CHG lamp lights up when charging begins. When the  /CHG lamp goes 
off, charging is completed.
AC-LS1A AC power adaptor (not supplied)
DC IN jack 
cover
To the wall outlet (mains)
Battery pack (S series) 
(not supplied)
Power cord
(mains lead)
Getting
 sta
rted
13
Still image recording* 
Still image playback*** 
Approximate battery life and number of images that can be recorded/played back 
640×480 image size, standard picture quality, no flash, and in NORMAL recording 
mode.
Recording at about 3-second intervals with the power save mode off (when continuous 
recording, the power save mode does not operate effectively.)
∗∗
When using a fully charged battery pack at a temperature of 25°C (77°F).
∗∗∗
Playing back single images in order at about 3-second intervals
Moving image recording
Approximate recording time in 160×112 image size.
When using a fully charged battery pack at a temperature of 25°C (77°F).
Notes 
The camera may not operate in an extremely cold location when using alkaline batteries.
Even when using an “InfoLITHIUM” battery pack (not supplied), the battery life and number 
of images will be decreased if you use your camera at low temperatures, use the flash, 
repeatedly turn the power on/off or use the zoom. 
The numbers of images shown on tables above are as a guide. The numbers may be smaller 
depending on conditions.
The capacity of the “Memory Stick” is limited. The above figures are a guide when you 
continuously record/play back while replacing the “Memory Stick.”
When LCD BACKLIGHT is set to BRIGHT, the battery life and number of images will be 
decreased. 
Battery life and number of images that can be recorded/played back
SONY alkaline batteries 
(supplied)
NP-FS11 (not supplied)**
Battery life 
(min.)
Number of 
images
Battery life 
(min.)
Number of 
images
LCD screen ON
Approx. 30
Approx. 600
Approx. 90
Approx. 1800
LCD screen OFF
Approx. 60
Approx. 1200
Approx. 120
Approx. 2400
SONY alkaline batteries 
(supplied)
NP-FS11 (not supplied)**
Battery life 
(min.)
Number of 
images
Battery life 
(min.)
Number of 
images
LCD screen ON
Approx. 60
Approx. 1200
Approx. 120
Approx. 2400
SONY alkaline batteries 
(supplied)
NP-FS11 (not supplied)*
LCD screen 
OFF (min.)
LCD screen 
ON (min.)
LCD screen 
OFF (min.)
LCD screen 
ON (min.)
Continuous 
recording
Approx. 60
Approx. 30
Approx. 120
Approx. 90
14
Approximate time to charge a completely discharged battery pack using the 
AC-LS1A AC power adaptor (not supplied) at a temperature of 25°C (77°F). 
Using a car battery
Use Sony DC adaptor/charger (not supplied).
Using your camera abroad
For details, see page 74.
When using the AC power adaptor
Be sure to use it near the wall outlet. If a malfunction occurs, disconnect the plug 
from the wall outlet.
Charging time
Battery pack
Full charge (min.)
NP-FS11 (not supplied)
Approx. 180
Using the AC power adaptor (not supplied)
1
Open the DC IN jack cover and connect the DC connecting cable to 
the DC IN jack of your camera with the 
v
 mark facing up.
2
Connect the power cord (mains lead) to the AC power adaptor (not 
supplied) and then to a wall outlet (mains). 
AC-LS1A AC power adaptor (not supplied)
DC IN jack 
cover
To the wall outlet (mains)
Power cord
(mains lead)
Page of 101
Display

Click on the first or last page to see other DSC-P30 / DSC-P50 (serv.man3) service manuals if exist.