DSC-P30, DSC-P50 (serv.man3) - Sony Digital Camera Service Manual (repair manual). Page 12

Read Sony DSC-P30 / DSC-P50 (serv.man3) Service Manual online

1-6
BBBB
 Rec
or
ding
23
Digital zoom function
This camera has a digital zoom function.
Digital zoom enlarges the image by digital processing and it starts to function when 
zoom exceeds 3
×
.
Using digital zoom
The maximum zoom magnification is 6
×
.
Digital zooming deteriorates the picture quality. When digital zoom is not 
necessary, set [DIGITAL ZOOM] to [OFF] in the setup settings (page 69).
Notes
Digital zoom does not work for moving images.
Use the LCD screen when using digital zoom function. Digitally zoomed images do not appear 
in the finder.
The AF frame (page 85) does not appear on the LCD screen. 
When you use the self-timer function, the subject is recorded about 10 seconds after 
you press the shutter button.
Clear the menu (page 40), then press the control button V (
). The 
 (self-timer) 
indicator appears on the LCD screen, and about 10 seconds after you press the shutter 
button, the subject is recorded. The self-timer lamp flashes and the beep sounds after 
you press the shutter button until the shutter is released. To cancel the self-timer 
recording, press the control button V (
) again. 
Using the self-timer
The T side of the bar shows the 
digital zooming zone.
Control button
Shutter button
Self-timer lamp
24
The factory setting is auto (no indicator). In this mode, the flash automatically 
strobes when the surroundings is dark. To change the flash mode, clear the menu 
(page 40), then press the 
control button v (
) repeatedly so that the flash mode 
indicator appears on the LCD screen.
Each time you press the control button v ( ), the indicator changes as follows. 
(No indicator) 
t   t 
 
t (No indicator)
 Forced flash:
The flash strobes regardless of the surrounding brightness.
No flash:
The flash does not strobe.
You can change the brightness of the flash with [ ±] (FLASH LEVEL) in the menu 
settings (page 42).
To reduce the red-eye phenomenon
Set [RED EYE REDUCTION] to [ON] in the setup settings, the flash strobes before 
recording to reduce the red-eye phenomenon (page 69). When [ON] is selected and 
the mode dial is set to 
 or 
 appears on the LCD screen.
Notes
When [ISO] is set to [AUTO] in the menu settings, the recommended shooting distance using 
the built-in flash is 0.3 m to 2.0 m (11 13/16 inches to 6 feet 6 3/4 inches). When it is not set to 
[AUTO], the flash may be ineffective even if the flash level is changed.
Red-eye reduction may not produce the desired effects depending on individual differences, the 
distance to the subject, if the subject does not see the pre-strobe, or other conditions. 
The flash effect is not obtained easily when you use forced flash in a bright location.
While charging the flash, the 
/CHG lamp flashes. After the charging is complete, the lamp 
goes out.
The flash does not function when recording moving images (excluding Clip Motion).
When you record images in a dark place with the camera set to 
 
(no flash), the shutter speed 
becomes slow, so using a tripod is recommended to prevent shaking. 
Recording images with the flash
Control button 
v
 
(
)
BBBB
 Rec
o
rd
ing
25
The AF illuminator is fill light to focus on a subject easily under dark conditions. Set 
[AF ILLUMINATOR] (page 69) to [ON] in the setup settings, 
 appears on the 
LCD screen and the AF illuminator emits light when the shutter button is pressed 
halfway. It keeps emitting light until the focus is locked.
Notes
If AF illuminator light does not reach the subject sufficiently or the subject has no contrast, 
focus will not be achieved. (Approximate distance up to 2.0 m (6 feet 6 3/4 inches) is 
recommended.)
In TWILIGHT mode (page 47), the AF illuminator will emit only when the flash mode is set to 
 (Forced flash).
Focus is achieved as long as AF illuminator light reaches to the subject even if its light is 
slightly out of the middle position of the subject.
The AF illuminator is a very bright light. Although it is safe to use, avoid shining it directly into 
someone’s eyes at a close distance.
Recording images with the AF illuminator
AF illuminator
26
Recording moving images
Moving images are recorded in MPEG format (page 38). 
To record moving images, press the POWER button to turn on the power and insert a 
“Memory Stick.”
 
1
Set the mode dial to SET UP.
2
Select [
] (CAMERA) with 
v
/
V
 on the 
control button, then press 
B
.
3
Select [MOVING IMAGE] with 
v
/
V
 on the 
control button, then press 
B
.
4
Select [MPEG MOVIE] with 
v
/
V
 on the 
control button, then press the center 
z
.
5
Set the mode dial to 
.
POWER
DISPLAY/LCD ON/OFF
CAMERA
MOVING IMAGE:
DATE/TIME:
DIGITAL ZOOM:
RED EYE REDUCTION:
AF ILLUMINATOR:
MPEG MOVIE
OFF
OFF
OFF
ON
PAGE SELECT
MPEG MOVIE
CLIP MOTION
CAMERA
MO
MOVING IMA
VING IMAGE:
GE:
DATE/TIME:
DIGITAL ZOOM:
RED EYE REDUCTION:
AF ILLUMINATOR:
OK
CAMERA
MOVING IMAGE:
DATE/TIME:
DIGITAL ZOOM:
RED EYE REDUCTION:
AF ILLUMINATOR:
MPEG MOVIE
OFF
OFF
OFF
ON
PAGE SELECT
Page of 101
Display

Click on the first or last page to see other DSC-P30 / DSC-P50 (serv.man3) service manuals if exist.