Read Sony DSC-N2 (serv.man2) Service Manual online
2-6
DSC-N2_L2
From the top spring position, cover new ornamental ring (A) on the 1 group frame.
Rotate the ornamental ring (A) over 90 degrees to spread the adhesive.
Note: Adhesive must not run off the lens-barrel.
Rotate the ornamental ring (A) over 90 degrees to spread the adhesive.
Note: Adhesive must not run off the lens-barrel.
Stiffen by leaving it for 60 minutes or more.
2-3-4. INSTALL NEW ORNAMENTAL RING (A)
Apply a thin coat of adhesive to the inside of ornamental ring (A).
Note: Use adhesive (Super X) or an equivalent article.
Note: Use adhesive (Super X) or an equivalent article.
Don’t use what becomes white after drying like a quick-drying glue.
Ornamental ring (A)
Ornamental ring (A)
Adhesive
Position of adhesive spreading
Note: Refer after the adhesive of the removed ring.
Note: Refer after the adhesive of the removed ring.
Wipe off when the adhesive adheres outside
or edge side on the ring.
or edge side on the ring.
Adhesive
0.1mm
1.5-2.0mm
0.5mm
Spring
Ornamental ring (A)
Turn on and off the power to check the opening and closing of the barrier block with the camera in horizontal, up and down directions
respectively.
Further, check the zoom motion.
Rotate the ornamental ring (A) lightly to check that it is not removed.
respectively.
Further, check the zoom motion.
Rotate the ornamental ring (A) lightly to check that it is not removed.
Click on the first or last page to see other DSC-N2 (serv.man2) service manuals if exist.