Read Sony DSC-J20 (serv.man2) Service Manual online
DSC-J20_ADJ
5-10
5-3-11. Set Language Destination
Note:
Finish all of the adjustment except for the Language Destination setting.
Once the Language Destination setting is finished, it cannot be reset.
Once the Language Destination setting is finished, it cannot be reset.
Service Tool
Put the folder “Service Tool” downloaded in “5-1-5. Setting the Adjustment Mode” (Page 5-3) in any place of the PC.
Connecting USB to PC
Connect the equipment as shown below. (Fig. 5-3-34)
Starting up the Service Tool
Double click the “ServiceTool_Ver[][][].exe” in the “Service Tool” folder to start up the Service Tool. (Fig. 5-3-35)
Personal Computer
Dedicated USB cable
Power/charge lamp
The setting is finished normally.
Fig. 5-3-36
The setting is complete.
Screen display
The setting is finished abnormally.
Fig. 5-3-37
Malfunction of Set
Language Destination
result
Language Destination
result
Example:
Please Plug in
USB!
Fig. 5-3-38
Malfunction of Set
Language Destination
result
Language Destination
result
Example:
Serial No.
Length ERROR
Setting order
The Language Destination setting order is as follows.
Confirm the indication
on the screen.
Press the “Read” button, “PRODUCT CODE” and “SERIAL No.” will displayed on the screen.
Select the correspond language destination from the pull-down menu, input the “SERIAL No.”, then press the “Write” button.
*1 The “SERIAL No.” is written on the bottom of the camera.
Select the correspond language destination from the pull-down menu, input the “SERIAL No.”, then press the “Write” button.
*1 The “SERIAL No.” is written on the bottom of the camera.
*2 Once the Language Destination setting is finished, it cannot be reset.
The camera restarts and switches to the Mass
Storage connection automatically.
Storage connection automatically.
Disconnect the camera from the dedicated USB
cable and perform the initial setting.
cable and perform the initial setting.
In case of the setting is finished normally,
the setting completion indication appears on
the screen. (Fig. 5-3-36)
the setting completion indication appears on
the screen. (Fig. 5-3-36)
In case of the setting is finished abnormally,
the following message appears on the screen.
(Fig. 5-3-37, 5-3-38)
In this case, perform the setting again upon
the message.
the following message appears on the screen.
(Fig. 5-3-37, 5-3-38)
In this case, perform the setting again upon
the message.
Finished abnormally.
Finished normally.
Check that the camera is on the adjustment mode.
* For the setting procedure of the adjustment mode, refer to “5-1-5. Setting the Adjustment Mode” (Page 5-3).
Fig. 5-3-34
Fig. 5-3-35
Click on the first or last page to see other DSC-J20 (serv.man2) service manuals if exist.