DSC-HX50, DSC-HX50V (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 14

DSC-HX50/HX50V_L2

1-11

Removal
1.   Turn on the power switch and extend the lens (TELE end).
2.   Detach the battery.
3.   Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
4.   Heat the Ornamental Ring A with a drier.
5.  Turn the Ornamental Ring A clockwise and counterclockwise to detach it.

 

A

Ornamental Ring A

Solvent

Tweezers

Drier

6.   Disengage the four claws and remove the Barrier Assy.

 

Claws

Barrier Assy

Installation
1.   Fit the four claws and attach the Barrier Assy.

 

Claws

Barrier Assy

Barrier Assy

2.   Attach two Barrier Tapes so that the end of each tape comes to the dent.

Note: Attach Barrier Tapes carefully so that they do not wrinkle.

3.   Attach the Ornamental Ring A and push it gently.

 

Ornamental Ring A

Barrier Tapes

Barrier Tapes

Removal
1.   Release the claw to detach the Z Retainer.
2.   Release the boss and the claw to detach the FG Retainer.
3.   Release the claw to detach the FPC Retainer.

 

Claw

Claw

Boss

FG Retainer

FPC Retainer

Z Retainer

Claw

4.   Unsolder the DC Motor Worm Assy at two locations shown below.
5.   Disconnect the flexible board from the connector on the LF-2038 Flexible Board.

 

Solders

Connector

Disconnect the flexible board.

DC Motor Worm Assy

LF-2038 Flexible Board