Read Sony XTL-75V Service Manual online
9
INSTALLATION OF FLAT CABLE (L) 26P
Note:
Follow the assembly procedure in the numerical order given.
SECTION 3
ASSEMBLY
7
two screws
(M2
(M2
×
3)
6
FFC cover (2)
5
5
3
B board
4
four screws
(B2.6
(B2.6
×
4)
2
two flat cables (L) 26P
(CN705, 706)
(CN705, 706)
4
screw
(B2.6
(B2.6
×
4)
B board
two flat cables (L) 26P
chassis (lower)
ass’y
ass’y
Note: No slack is allowed.
filament tape 16
×
50
8
Using a filament tape 16
×
50,
stick two flat cables (L) 26P
to the chassis bottom without a slack
as shown in the figfure.
to the chassis bottom without a slack
as shown in the figfure.
base ass’y
1
Pull the base ass’y
in the direction of arrow A.
in the direction of arrow A.
A
0
Pull the flat cable (L) 26P in the direction of arrow B,
and stick it to the sheet (FFC) with an adhesive tape.
and stick it to the sheet (FFC) with an adhesive tape.
DC motor (small type) (slide) (M21)
B
adhesive tape
sheet (FFC)
qs
screw (M2
×
3)
qa
FFC cover (1)
0
Pull the flat cable (L) 26P
in the direction of arrow C,
and stick it to the sheet (FFC)
with an adhesive tape.
in the direction of arrow C,
and stick it to the sheet (FFC)
with an adhesive tape.
C
adhesive tape
sheet (FFC)
9
flat cable (L) 26P
(CN101)
(CN101)
9
Let the flat cable (L) 26P through
under DC motor (small type) (slide) (M21)
as shown in the figure, and connect to
the connector (CN102).
under DC motor (small type) (slide) (M21)
as shown in the figure, and connect to
the connector (CN102).
Click on the first or last page to see other XTL-75V service manuals if exist.