XR-CA330, XR-CA340 - Sony Car Audio Service Manual (repair manual). Page 6

Read Sony XR-CA330 / XR-CA340 Service Manual online

6
XR-CA330/CA340
BUS
AUDIO IN
AUDIO
OUT
to the interface cable of a car telephone
to the +12 V power terminal which is energized at the accessory position
of the ignition key switch
Notes
• If there is no accessory position, connect to the +12 V power (battery)
terminal which is energized at all times.
Be sure to connect the black earth lead to it first.
• When your car has a built-in FM/AM aerial in the rear/side glass, see 
“Notes on the control and power supply leads.”
to the power aerial control lead or power supply lead of aerial booster
amplifier
Notes
• It is not necessary to connect this lead if there is no power aerial or aeria
booster, or with a manually-operated telescopic aerial.
• When your car has a built-in FM/AM aerial in the rear/side glass, see  
“Notes on the control and power supply leads.”
 AUDIO
OUT
from a car aerial
BUS CONTROL IN
Fuse (10 A)
7
BUS AUDIO IN
AMP REM
Blue/white striped
Max. supply current 0.3 A
Max. supply current 0.1 A
ANT REM
Blue
Sky blue
ATT
Red
Yellow
Black
Purple
Green
Grey
White
Right
Left
Right
Left
to AMP REMOTE IN of the optional power amplifier
This connection is only for ampilifiers. Connecting any other system may
damage the unit.
Source selector
(not supplied)
Supplied with the CD/MD changer
Supplied with the XA-C30
RCA pin cord (not supplied)
Notes on the control and power supply leads
• The power aerial control lead (blue) supplies +12 V DC when you turn on the unit.
•  When your car has a built-in FM/AM aerial in the rear/side glass, it is necessary to connect the power aerial
control lead (blue) or the accessory power input lead (red) to the power terminal of the existing aerial booster.
For details, consult your dealer.
• A power aerial without a relay box cannot be used with this unit.
Memory hold connection
When the yellow power input lead is connected, power will always be supplied to the memory circuit even when
the ignition switch is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the
speakers may be damaged.
• Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the
right speaker with those of the left speaker.
• Do not attempt to connect the speakers in parallel.
• Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may
damage the active speakers. Be sure to connect passive speakers to these terminals.
to the +12 V power terminal which is energized at all times
Be sure to connect the black earth lead first.
to a metal place in the car
First connect the black earth lead, then connect the yellow and red  
power input leads.
Connection diagram
White/black striped
Grey/black striped
Green/black striped
Purple/black striped
XR-CA340 only
Page of 35
Display

Click on the first or last page to see other XR-CA330 / XR-CA340 service manuals if exist.