XR-C6103SP - Sony Car Audio Service Manual (repair manual). Page 15

Read Sony XR-C6103SP Service Manual online

– 15 –
DOLBY Level Adjustment
Setting:
Preset 
[3]
 (DOLBY) button
: NR OFF
SEL (BAS) button
: Center
SEL (TRE) button
: Center
SEL (BAL) button
: Center
SEL (FAD) button
: Center
SEL (VOL) button
: Maximum
D-BASS control
: OFF
Procedure:
1. Put the set into the FWD PB mode.
2. Adjust RV121 (L-CH) and RV221 (R-CH) so that the level
meter reading is –6 ± 1 dB (0.35 to 0.43 V).
Adjustment Location: See page 18.
TUNER  SECTION
0 dB=1 µV
Cautions during repair
When the tuner unit is defective, replace it by a new one because
its internal block is difficult to repair.
Note: 
Adjust the tuner section in the sequence shown below.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment
3. AM (MW) Auto Scan/Stop Level Adjustment
4. FM POLAR Adjustment
FM Auto Scan/Stop Level Adjustment
Setting:
[SOURCE]
 button: FM
Procedure:
1. Set to the test mode. (See page 14).
2. Push the 
[SOURCE]
 button and set to FM.
Display
3. Push the preset 
[3]
 button.
Display
4. Adjust with the volume RV2 on TU1 so that the “FM” indica-
tion turns to “FM0” indication on the display window.
But, in case of already indicated “FM0”, turn the RV2 so that
put  out light “0” indication and adjustment.
Display
Adjustment Location: See page 18.
set
+
test tape
P-4-D400
(400 Hz, 0 dB)
MAIN board
level meter
MAIN board
TP (DOLBY L)/
TP (DOLBY R)
TP (GND)
    
      
FM RF signal
generator
Carrier frequency : 98.0 MHz
Output level
: 22 dB (12.6 
µ
V)
Mode
: mono
Modulation
: 1 kHz, 22.5 kHz deviation (30%)
0.01 
µ
F
set
antenna jack (J1)
FM
SHUF1
FM
SHUF1
SHUF1
Page of 38
Display

Click on the first or last page to see other XR-C6103SP service manuals if exist.