Read Sony XM-7527 Service Manual online
XM-7527
11
11
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
C
: panel designation.
•
U
: B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from +12V and REMOTE terminals.
• Voltages and waveforms are dc with respect to ground
under no-signal conditions.
no mark: POWER ON
no mark: POWER ON
*
: Impossible to mersure
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
• Signal path.
F
: AUDIO
For printed wiring boards.
Note:
• X
: parts extracted from the component side.
5-3. IC BLOCK DIAGRAM
• POWER section
IC901
IC901
µ
PC494G2
4
1
2
3
5
6
7 8
9
10
16 15
14
13
12 11
ERROR
0.1V
REG.
REF.
OSC
ERROR
Click on the first or last page to see other XM-7527 service manuals if exist.