XAV-W600, XAV-W650BT - Sony Car Audio Service Manual (repair manual). Page 13

To capture your voice during handsfree calling, you 
need to install the microphone ʕ.

Installing the microphone

ʖ

ʕ

Clip (not supplied)

ʕ

Installation

When mounting in a Japanese car, see “Mounting 
the unit in a Japanese car” (page 37).

Mounting the unit with an installation kit 
(not supplied)

Before installing, make sure the catches on both 
sides of the bracket are bent inwards 3.5 mm (

5

/

32

 

in).

1

Position the bracket inside the 
dashboard, then bend the claws outward 
for a tight fit.

2

Mount the unit onto the bracket.

Note
If the catches are straight or bent outwards, the unit will 
not be installed securely and may spring out.

Mounting the unit in the dashboard

Catch

Bracket

Larger than 
182 mm (7 

1

/

4

 in)

Larger than 
111 mm (4 

3

/

8

 in)

Bracket

ˎ It is extremely dangerous if the cord becomes 

wound around the steering column or gearstick. 
Be sure to keep it and other parts from interfering 
with your driving operations.

ˎ If airbags or any other shock-absorbing 

equipment are in your car, contact the store 
where you purchased this unit, or the car dealer, 
before installation.

Note
Before attaching the double-sided tape ʖ, clean the 
surface of the dashboard with a dry cloth.

Installation of the connection cable RC-SR1 (not 
supplied) is required before use.

To enable the steering wheel remote control, select 
[General Settings] q [User Defined] to make the 
registration (page 19).
When the registration is complete, the steering 
wheel remote control becomes available.

ˎ Refer to the support sites on the back cover for 

details, then connect each lead properly to the 
appropriate leads. Making an improper connection 
may damage the unit.

ˎ Consulting the dealer or an experienced technician 

for help is recommended.

To enable the wired remote control, set [Steering 
Control] in [General Settings] to [Preset] (page 19).

Installation of the rearview camera (not supplied) is 
required before use.
The image of a rearview camera connected to the 
CAMERA IN terminal is displayed when:

ˋ the back lamp of your car lights up (or the shift 

lever is set to the R (reverse) position).

ˋ you press HOME, then touch [Rear Camera].

ˋ you press and hold DSPL then touch [Rear 

Camera] if [SOURCE Key Func.] is set to [DSPL] 

Using the wired remote control

Using the rearview camera

When replacing the fuse, be sure to 
use one matching the amperage 
rating stated on the original fuse. If 
the fuse blows, check the power 
connection and replace the fuse. If 
the fuse blows again after 
replacement, there may be an 
internal malfunction. In such a case, consult your 
nearest Sony dealer.

Fuse replacement

Fuse (10 A)

Mounting the unit in a Japanese car

You may not be able to install this unit in some 
Japanese cars. In such a case, consult your Sony 
dealer.

When mounting this unit to the preinstalled 
brackets of your car, use the supplied screws ʔ in 
the appropriate screw holes based on your car: T 
for TOYOTA, M for MITSUBISHI and N for NISSAN.

Note
To prevent a malfunction, install only with the supplied 
screws ʔ.

ʔ

To the dashboard/center console

Parts supplied with your 
car

ʔ

Bracket

Bracket