CDX-C560RDS - Sony Car Audio Service Manual (repair manual). Page 19

– 19 –

This set have the test mode function. In the test mode, FM Auto Scan/
Stop Level and MW Auto Scan/Stop Level adjustments can be
performed easier than it in ordinary procedure.

<Set the Test Mode>
1. Set the “OFF” mode.
2. Push the preset  4  button.
3. Push the preset  5  button.
4. Press the preset  1  button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.

<Release the Test Mode>
1. Push the  OFF  button.

When the tuner unit is defective, replace it by a new one because
its internal block is difficult to repair.

The adjustments of tuner section, should be performed according to
the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment
3. FM RDS S-Meter Adjustment
4. MW Auto Scan/Stop Level Adjustment

FM RF signal

generator

0.01 µF

antenna
terminal

set

Carrier frequency : 98.00 MHz
Output level

: 22 dB (12.6 µV)

Mode

: mono

Modulation

: 1 kHz, 22.5 kHz deviation (30%)

Procedure :
1. Set to the test mode.
2. Push the  SOURCE  button and set to FM.

Display

D-BASS switch : OFF
SOURCE button : FM

3. Push the preset  3  button.

Display

REG

SHUF1

4. Adjust with the volume RV2 on TU1 so that the “FM” indication

turns to “FM0” indication on the display window.
But, in case of already indicated “FM0”, turn the RV2 so that put
out light “0” indication and adjustment.

Display

Adjustment Location : See page 21.

REG

SHUF1

REG

SHUF1