Read Sony ZS-Y2L Service Manual online
13
ZS-Y2L
SECTION 5
DIAGRAMS
•
Note for Printed Wiring Boards and Schematic Diagrams
Note on Schematic Diagram:
•
All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
•
All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
• C
: panel designation.
• A
: B+ Line.
• B
: B– Line.
• H
: adjustment for repair.
•
Power voltage is dc 9V and fed with regulated dc power
supply from battery terminal.
no mark : FM
supply from battery terminal.
no mark : FM
〈〈
〉〉
: MW
[ ]
: LW
(
) : CD PLAY
•
Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
•
Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
Voltage variations may be noted due to normal produc-
tion tolerances.
•
Circled numbers refer to waveforms.
•
Signal path.
F
: FM
f
: MW/LW
J
: CD PLAY (ANALOG OUT)
c
: CD PLAY (DIGITAL OUT)
j
: LINE IN
Note on Printed Wiring Board:
• X
: parts extracted from the component side.
• Y
: parts extracted from the conductor side.
• W
: indicates side identified with part number.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
Click on the first or last page to see other ZS-Y2L service manuals if exist.