Read Sony XDR-S40DBP Service Manual online
XDR-S40DBP
9
2-9. MODULE ASSY (DAB MODULE) (DAB1)
2-8. MAIN BOARD
long side
notch
short side
Note: When installing the connector
pin 3P (CN104), check the
direction to install.
1 Remove three solders.
3 sheet (MD insulating)
4 module assy (DAB module)
(DAB1)
to module assy
(DAB module) (DAB1)
(DAB module) (DAB1)
to MAIN board
2 connector pin 3P
(CN104)
–
DAB module block rear top side view
–
3 Remove three solders.
8 Remove six solders.
8 Remove six solders.
9 wire (6 core)
0 MAIN board
9 wire (6 core)
5 Remove three solders.
6 two claws
7 holder (antenna)
block
3 Remove eighteen solders.
3 Remove thirty solders.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
1 Remove the solder.
2 terminal
(module)
2 terminal
(module)
2 terminal (module)
2 terminal (module)
4 DAB module block
terminal
(module)
(module)
MAIN board
solder
holder (antenna)
Cut this part.
solder
1.5 mm
module assy (DAB module)
(DAB1)
(DAB1)
7HUPLQDOPRGXOHVHWWLQJ
–
0$,1ERDUGEORFNUHDUWRSVLGHYLHZ
–
Note: When the holder (antenna) replacing,
cut off the part as shown in the
figure
below.
Click on the first or last page to see other XDR-S40DBP service manuals if exist.