Read Sony TC-TX101 Service Manual online
– 3 –
P707, 909
PFJ-1
(Power Supply jig)
(Power Supply jig)
POWER SW
Connector Cable 17P
(supplied with set)
(supplied with set)
set
Conversion Board
(J-2501-144-A)
(J-2501-144-A)
SYSTEM CONTROL
Power Function
SECTION 1
SERVICE NOTE
1-1. SUPPLYING POWER DURING SERVICING
This equipment cannot operate without using a separate power
supply. Connect this set to the HCD-101.
To apply power set the SYSTEM POWER switch of HCD-101.
When other units are not available use the PFJ-1 power supply jig.
When using the PFJ-1, press the POWER switch of the conversion
board to turn on the power.
supply. Connect this set to the HCD-101.
To apply power set the SYSTEM POWER switch of HCD-101.
When other units are not available use the PFJ-1 power supply jig.
When using the PFJ-1, press the POWER switch of the conversion
board to turn on the power.
•
Connection Diagram
*
When checking the recording
function of TC-TX101, select
any function other than TAPE
using the Function key of
the conversion board before
check.
any function other than TAPE
using the Function key of
the conversion board before
check.
Click on the first or last page to see other TC-TX101 service manuals if exist.