Read Sony STR-DN1030 Service Manual online
STR-DN1030
14
HISTORY MODE
The state that the set is used is memorized.
Procedure:
1. While pressing the [TONE MODE] and [MUSIC] buttons,
The state that the set is used is memorized.
Procedure:
1. While pressing the [TONE MODE] and [MUSIC] buttons,
press the [
?/1
] button to turn on the power and “HISTORY” is
displayed.
2. Each time the [M]/[m] buttons on the remote commander is
pressed, the item is switched in order as follows.
Items
Display
Protector count
COUNT xx
Total single power on time
SxxxxxHxxM
Sound fi eld
SOUNDFIELD
Input function
FUNCTION
Input mode
INPUT MODE
Digital select
DIG SELECT
Stream information
STREAMINFO
Signal confi guration
CONF xxxxx
Headphones
HEADPH xxx
Volume
VOL xx
Bass
BASS xxxdB
Treble
TREB xxxdB
Level FL/FR
FL/R xxxxxx
Level SL/SR
SL/R xxxxxx
Level CT/SW
C/SW xxxxxx
Level BL/BR
BL/R xxxxxx
Level LH/RH
HL/R xxxxxx
Total power on time
TxxxxxHxxM
Muting
MUTING xxx
Power on counter
(Rebox test mode)
(Rebox test mode)
REBOX xxxx
Protector status
PROT xxxx
Temperature status
TEMP xxxc
VACS step
VACS xx
USB UPDATE TEST MODE
To update Main MCU, Video MCU, DSP serial fl ash and Hudson
II software through USB.
Procedure:
1. Plug in USB device in power off condition.
2. While pressing the [TONE MODE] and the [DISPLAY]
To update Main MCU, Video MCU, DSP serial fl ash and Hudson
II software through USB.
Procedure:
1. Plug in USB device in power off condition.
2. While pressing the [TONE MODE] and the [DISPLAY]
buttons, press the [
?/1
] button to turn on the main power.
3. The message “UPDATING” appears and active standby LED
will blinking.
4. If the updating progress succeed, the active standby LED
will blink once per 0.1 seconds and message “COMPLETE”
appears.
appears.
5. If the updating progress fail, the active standby LED
will blink once per 1 seconds and message “ERROR”
appears.
appears.
USB UPDATE VERSION MODE
Function that displays the version number to check whether SPDIF
update is necessary or not.
Procedure:
1. While pressing [TONE MODE] and [DIMMER] buttons,
Function that displays the version number to check whether SPDIF
update is necessary or not.
Procedure:
1. While pressing [TONE MODE] and [DIMMER] buttons,
press the [
?/1
] button to turn on the main power.
2. The message “VER X.XXX” is displayed after 30 seconds.
“X.XXX” is calculated by adding all fi rmware version.
Example:
(MAIN ver. + DSP ver. + HDMI ver. + FARO ver. + BridgeCo
+ 5)/10 = Displayed version
+ 5)/10 = Displayed version
MAIN = 1.02, DSP = 1.01, HDMI = 1.00, FARO = 1.03,
BridgeCo = 1.01
BridgeCo = 1.01
↓
(1.02 + 1.01 + 1.00 + 1.03 + 1.01 + 5)/10 = 1.007
1.007 = X.XXX
Click on the first or last page to see other STR-DN1030 service manuals if exist.