Read Sony STR-DG820 Service Manual online
STR-DG820
4
CONNECTOR AND SPEAKER BOARDS DISCRIMINA-
TION
In this set, the CONNECTOR and SPEAKER baords have been
changed in the midway of production. Repair after distinguishing
each type set to doing the repair referring to the following.
TION
In this set, the CONNECTOR and SPEAKER baords have been
changed in the midway of production. Repair after distinguishing
each type set to doing the repair referring to the following.
– CONNECTOR Board (Suffix-11/-12)
(Component Side) –
(Component Side) –
– CONNECTOR Board (Suffix-13)
(Component Side) –
(Component Side) –
Note: In
suffi x-11/-12 and suffi x-13 of CONNECTOR board, the shape
of the board is quite different. It is possible to distinguish in the
form of the board.
form of the board.
– SPEAKER Board (Component Side) –
1
7
1
5
CNP285
CNP286
Former : 1-875-925-11 or
1-875-925-12
New :
1-875-925-13
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. See the following table
to solve the problem.
message. You can check the condition of the
system by the message. See the following table
to solve the problem.
PROTECTOR
• Irregular current is output from the
speakers. The receiver will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
For other messages, see “Message list after
Auto Calibration measurement” (Refer to
Operating Instructions) and “XM Radio
messages list” (Refer to Operating Instructions).
Auto Calibration measurement” (Refer to
Operating Instructions) and “XM Radio
messages list” (Refer to Operating Instructions).
If you are unable to remedy the
problem
problem
Clearing the receiver’s memory may remedy
the problem. Refer to this page “Reference
sections for clearing the receiver’s memory”.
However, note that all memorized settings will
be reset to their factory settings and you will
have to readjust all settings on the receiver.
the problem. Refer to this page “Reference
sections for clearing the receiver’s memory”.
However, note that all memorized settings will
be reset to their factory settings and you will
have to readjust all settings on the receiver.
Reference sections for clearing
the receiver’s memory
the receiver’s memory
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press POWER to turn off the
receiver.
receiver.
2
Hold down TONE MODE and
2CH/A.DIRECT and then press
POWER to turn on the receiver.
2CH/A.DIRECT and then press
POWER to turn on the receiver.
3
Release the TONE MODE and
2CH/A.DIRECT after a few
seconds.
2CH/A.DIRECT after a few
seconds.
After “CLEARING” appears on the
display for a while, “CLEARED”
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
display for a while, “CLEARED”
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Performing initial setup
operations
operations
SPEAKERS
(OFF/A/B/A+B)
PHONES
VIDEO 2 IN/PORTABLE AV IN
VIDEO
L AUDIO R
AUTO CAL MIC
MEMORY/
ENTER
2CH/
A.DIRECT
A.F.D.
MOVIE
MUSIC
DIMMER
INPUT SELECTOR
TONE MODE
ON/STANDBY
TUNING MODE
POWER
TUNING
DISPLAY
INPUT MODE
MASTER VOLUME
TONE
1,2
2,3
2,3
Be sure to use the buttons on the receiver for
this operation.
this operation.
1
Press
/ to turn off the
receiver.
2
While holding down MUSIC,
press
press
/.
“S.F. CLEAR” appears on the display and
all sound fields are reset to their initial
setting.
all sound fields are reset to their initial
setting.
SPEAKERS
(OFF/A/B/A+B)
PHONES
VIDEO 2 IN/PORTABLE AV IN
VIDEO
L AUDIO R
AUTO CAL MIC
MEMORY/
ENTER
2CH/
A.DIRECT
A.F.D.
MOVIE
MUSIC
DIMMER
INPUT SELECTOR
TONE MODE
ON/STANDBY
TUNING MODE
POWER
TUNING
DISPLAY
INPUT MODE
MASTER VOLUME
TONE
1,2
2
Ver. 1.2
Click on the first or last page to see other STR-DG820 service manuals if exist.