Read Sony SCD-1 / SCD-777ES (serv.man2) Service Manual online
13
REMOVAL OF LOADING ASS’Y AT POWER OFF.
1
four hexagon socket bolts
(M4
(M4
×
8)
stabilizer ass’y
spindle motor shaft
1
four hexagon socket bolts
(M4
(M4
×
8)
2
Raise the loading ass’y 5cm uprightly.
(Remove the stabilizer ass’y from
the spindle motor shaft.)
Note: The loading ass’y must be
(Remove the stabilizer ass’y from
the spindle motor shaft.)
Note: The loading ass’y must be
raised uprightly with both
hands, because it is heavy.
hands, because it is heavy.
Note: In raising the loading ass’y,
do not move it to the left and
right when it is below 5cm.
(Otherwise, the spindle motor
shaft could be bent.)
right when it is below 5cm.
(Otherwise, the spindle motor
shaft could be bent.)
@
6
stabilizer ass’y
5
Rotate the pulley (first) ass’y toward direction
B
,
and open the panel (loading) ass’y.
9
loading ass’y section
7
disc
8
connector (CN503)
4
Raise slowly the rear side of
loading ass’y toward the
direction
loading ass’y toward the
direction
A
.
A
B
3
Place the front side of
loading ass’y on the step at
the rear side of front panel
as shown.
loading ass’y on the step at
the rear side of front panel
as shown.
panel (loading) ass’y
Click on the first or last page to see other SCD-1 / SCD-777ES (serv.man2) service manuals if exist.