SA-WGT5D - Sony Audio Service Manual (repair manual). Page 122

1.0

2015.06

New

1.1

2015.08

Addition of UK, RU, SP6, AR models

Change of FL, IR, JACK, KEY, MIC, MIC-HUB and USB boards (Suffi x-12) 

Change of Ref. No. from CN902 to CN901 on the ARAGON-MOTHER board 

Deletion of Part for Ref. No. R626, R627, R628, R629, R654, R657 and Addition of Part for Ref. No.  

FB626, FB627, FB628, FB629, FB654, FB657 on the ARAGON-MOTHER board 

Change of Part for Ref. No. R462, R466, R528, R529, R534 and R535 on the ARAGON-MOTHER board 

Change of Part No. for complete D-AMP board 

Change of Part for Ref. No. C2105, C2108, R2006, R2010, R2040, R2042, R2073, R2077, R2107 and 

R2109 on the D-AMP board 

Deletion of Part for Ref. No. C2107, C2153, C2528, C2539, R2553 and R2584 on the D-AMP board 

Deletion of Part for Ref. No. D3701, D3704, D3709 and D3710 on the USB board 

Change of Part No. for TOP PANEL ASSY (Ref. No. 56) 

Addition of FERRITE CORE (Ref. No. FC7), SARANET CUSHION (LXWXT) 

and CUSHION (SARANET-A) (AEP, RU, UK, AUS, SP6 models)

Deletion of PACKING (TOP) 

Deletion of FERRITE CORE (Ref. No. FC1, FC3, FC4, FC5) and HIMELON 45 (4 pieces) and  

Addition of CLAMP (1 piece) (E4, EA, LA, AR models)

Addition of SARANET CUSHION (7T25) (4 pieces)

Addition of FERRITE CORE (Ref. No. FC6) and SARANET CUSHION (30X50)

Change of Part No. for SWITCHING REGULATOR (SSN-152AD) (Ref. No. SWR1)

Change of Part No. for PANEL LOADING (R) SHEET (Ref. No. 403) and PANEL LOADING (L) 

SHEET (Ref. No. 404) 

(SMR-15018)

 

 

 

 

 

 

 

 

How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use 
the PDF fi le search function to fi nd one.

e.g.) If a contact point is shown as 

, follow the procedure below.

Procedure:
1.  Press the [F] key while pressing the [Ctrl] key.
2.  Input “>001Z” in the search box and press the [Enter] key.
3.  The relevant part (page), where the contact point is shown, appears.

Note: If you still see the original page, press the [Enter] key again.