Read Sony SA-WCT260 Service Manual online
SA-WCT260
9
2-7. SUB AMP BLOCK
1 two tapping screws
(BVTP3.5
u 14)
1 two tapping screws
(BVTP3.5
u 14)
3 speaker connector
(CN105)
4 sub AMP block
2 Remove the sub AMP block
in the direction of an arrow.
– Rear side view –
sub AMP block
screw hole
:ire seWWiQJ
Note: Push the speaker wire inside as arrow direction
to avoid sub AMP block screw hole.
SW cabinet
2-8. SUB MAIN BOARD
9 three claws
0 holder (air)
block
qa SUB MAIN board
6 two screws
(BVTP3
u 8)
4 two screws
(BV3)
IC401
7 three screws
(BV3)
7 screw (BV3)
5 heat sink (AMP)
Note: When you install the heat sink (AMP),
spread the compound referring to “NOTE
OF REPLACING THE IC104 ON THE
SUB MAIN BOARD AND THE COMPLETE
SUB MAIN BOARD” on servicing notes
(page
3).
3 connector
(CN
901
)
2 connector
(CN
106
)
1 Remove two wires from lead pin.
8 Remove the SUB MAIN board block
in the direction of an arrow.
– Sub AMP block rear side view –
SUB MAIN board
POWER board
lead pin
:ire seWWiQJ
Click on the first or last page to see other SA-WCT260 service manuals if exist.