SA-RV900 - Sony Audio Service Manual (repair manual). Page 3

Read Sony SA-RV900 Service Manual online

3
3
SA-RV900
SECTION 1
GENERAL
• Location of controls
SECTION 2
DIAGRAMS
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted.  pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 
1
/
4
 
W or less unless otherwise
specified.
• C : panel designation.
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
: Pattern from the side which enables seeing.
: B+ Line.
: B– Line.
• Voltages are dc with respect to ground under no-signal con-
ditions.
no mark : Power on
• Voltages are taken with a VOM (Input impedance 10MΩ).
Voltage variations may be noted due to normal preduction
tolerances.
• Signal path.
K
: AUDIO
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND
SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
Note:
The components identified by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specified.
• Abbreviation
E2
: Central and South America model
E3
: Middle and Near East model
E51 : Chilean and Peruvian model
SP
: Singapore model
MX
: Mexican model
AUS : Australia model
ON/OFF 
SUBWOOFER
ON/OFF
POWER ON/OFF
indicator
LINE IN
SPEAKER IN
SPEAKER OUT
VOLTAGE SELECTOR
(E2,E3,E51,SP model only)
LINE IN
VOL
REVERSE
PHASE
NORMAL
VOL
PHASE
SPEAKER
IN
L
R
SPEAKER
OUT
L
R
120V
220V
230 - 240V
VOLTAGE SELECTOR
  – Front view  –
  – Rear view  –
2-1.  IC BLOCK DIAGRAMS
IC201
NJM2072D (MAIN BOARD)
1
2
3
4
8
7
6
5
GND
AMP OUT
GAIN CONT
INPUT
VCC
OUTPUT2
OUTPUT1
RECOVERY
TIME CAP
Page of 8
Display

Click on the first or last page to see other SA-RV900 service manuals if exist.