Read Sony NWZ-ZX1 Service Manual online
NWZ-ZX1
18
2-9. MAIN BOARD-1
•
Continued on 2-10 (page 19).
Note 1: Refer to “NOTE OF MAIN BOARD HANDLING” on page 4.
– Rear top view –
MAIN board
:LUHVHWWLQJ
[white/red]
[white]
[black (thin)]
LCD flexible board
3 Open the connector.
guide line
TP relay FPC assy
MAIN board
OK
NG
NG
Insert is shallow.
[black (thick)]
HP board
2 cushion
(shield)
(shield)
1 Remove four solders of wire.
4 SW flexible board
5 LCD flexible board
6 touch panel flexible board
MAIN board
center
3DVWLQJSRVLWLRQRIFXVKLRQVKLHOG
SW flexible board
cushion (shield)
,QVWDOOHGSRVLWLRQRI/&'IOH[LEOHERDUG
GND wire
two ribs
two grooves
OK
NG
Note 7: When installing the SW
flexible board, insert it
fully to the connector.
Inserted to fully.
Note 8:
There is a possibility of damaging LCD flexible board
when removing the direction of below figure of “NG”.
Note 9:
When installing LCD flexible board,
align two grooves and two ribs.
If putting into the connector shift
groove and rib, connector will be
broken.
Note 2: Do not fold the SW flexible board with tweezers.
Note 3: Do not pressing the SW flexible board with finger nails.
Note 4: When locking the connector, press the middle position
Note 3: Do not pressing the SW flexible board with finger nails.
Note 4: When locking the connector, press the middle position
of connector lever.
Note 5: Do not close the connector lever before the SW flexible
board
board
insertion.
Note 6: If the connector lever is closed, need to open
the connector lever fully, then insert the SW flexible
board and close the connector lever.
1RWHVIRUUHPRYLQJWKH/&'IOH[LEOHERDUG
Click on the first or last page to see other NWZ-ZX1 service manuals if exist.