Read Sony NWZ-S763 / NWZ-S763BT / NWZ-S764 / NWZ-S764BT / NWZ-S765 Service Manual online
NWZ-S763/S763BT/S764/S764BT/S765
8
2-3. OPEN THE SHORT-LAND
Note 1: This illustration sees the mechanical commonness block from LCD assy side (lower half).
Note 2: Make sure to remove one solder to become an open state before disassembling the mechanical commonness block.
Note 3: Solder the short-land after all wirings are connected when you exchanged some mounted board.
Note 2: Make sure to remove one solder to become an open state before disassembling the mechanical commonness block.
Note 3: Solder the short-land after all wirings are connected when you exchanged some mounted board.
2-4. CAP
1 Remove the solder of short-land.
1
screw
(M1.4
u 2.5)
2
Push the part
A.
A
3
Move the panel (rear) assy in the
direction of the arrow
B a little.
4
Remove the claw after moving the
cap in the direction of the arrow
C.
4
Remove the claw after moving the
cap in the direction of the arrow
C.
B
C
1
screw
(M1.4
u 2.5)
5
cap
– Front bottom view –
Note: When installing the cap, take
care not to crush two claws.
Click on the first or last page to see other NWZ-S763 / NWZ-S763BT / NWZ-S764 / NWZ-S764BT / NWZ-S765 service manuals if exist.