Read Sony MDS-B5 Service Manual online
— 37 —
3-4-2. Operating the Continuous Recording Mode
1. Entering the continuous recording mode
1 Set the MO disc in the unit.
2 Rotate the AMS knob and display “CREC MODE”.
3 Press the ENTER/YES button to change the display to “CREC IN”.
4 When access completes, the display changes to “CREC (
2 Rotate the AMS knob and display “CREC MODE”.
3 Press the ENTER/YES button to change the display to “CREC IN”.
4 When access completes, the display changes to “CREC (
)”.
Note : The “ ” displayed are arbitrary numbers.
2. Changing the parts to be recorded
1 When the ENTER/YES button is pressed during continuous recording, the display changes to “CREC MID”, “CREC OUT” .
When pressed another time, the parts to be recorded can be changed.
2 When access completes, the display changes to “CREC (
)”.
Note : The “ ” displayed are arbitrary numbers.
3. Ending the continuous recording mode
1 Press the EDIT/NO button. The display changes to “CREC MODE”.
2 Press the EJECT button and remove the disc.
2 Press the EJECT button and remove the disc.
Note 1 :
The recording start addresses for IN, MID, and OUT are as follows.
IN
IN
40h cluster
MID 300h cluster
OUT 700h cluster
OUT 700h cluster
Note 2 :
The EDIT/NO button can be used to stop recording anytime.
Note 3 :
During the test mode, the erasing-protection tab will not be detected. Therefore be careful not to set the continuous recording mode
when a disc not to be erased is set in the unit.
when a disc not to be erased is set in the unit.
Note 4 :
Do not perform continuous recording for long periods of time above 5 minutes.
Note 5 :
During continuous recording, be careful not to apply vibration.
3-4-3. Non-Volatile Memory Mode
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If set accidentally, press the EDIT/NO button immediately to exit it.
It is not used in servicing. If set accidentally, press the EDIT/NO button immediately to exit it.
3-5. Functions of Other buttons
Contents
Sets continuous playback when pressed in the STOP state. When pressed during continuous playback, the tracking servo turns ON/OFF.
Stops continuous playback and continuous recording.
The sled moves to the outer circumference only when this is pressed.
The sled moves to the inner circumference only when this is pressed.
Turns recording ON/OFF when pressed during continuous playback.
Switches between the pit and groove modes when pressed.
Switches the spindle servo mode (CLVS and A).
Switches the display when pressed.Returns to previous step. Stops operations.
Function
^
p
)
0
r
SINGLE
A. MODE
DISPLAY
Note : The erasing-protection tab is not detected during the test mode. Recording will start regardless of the position of the erasing-protection
tab when the
r (REC) button is pressed.
Click on the first or last page to see other MDS-B5 service manuals if exist.