ICF-CDK70 - Sony Audio Service Manual (repair manual). Page 3

The laser diode in the optical pick-up block may suffer electrostat-
ic break-down because of the potential difference generated by the 
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also 
use the procedure in the printed matter which is included in the 
repair parts.
The fl exible board is easily damaged and should be handled with 
care.

NOTES  ON  LASER  DIODE  EMISSION  CHECK
The laser beam on this model is concentrated so as to be focused 
on the disc refl ective surface by the objective lens in the optical 
pickup block. Therefore, when checking the laser diode emission, 
observe from more than 30 cm away from the objective lens.

UNLEADED  SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with 

the lead free mark due to their particular size)

Unleaded solder has the following characteristics.
  •  Unleaded solder melts at a temperature about 40 °C higher 

than ordinary solder.

    Ordinary soldering irons can be used but the iron tip has to be 

applied to the solder joint for a slightly longer time.

    Soldering irons using a temperature regulator should be set to 

about 350 °C.
Caution:  The printed pattern (copper foil) may peel away if the 

heated tip is applied for too long, so be careful!

  •   Strong viscosity
    Unleaded solder is more viscou-s (sticky, less prone to fl ow) 

than ordinary solder so use caution not to let solder bridges 
occur such as on IC pins, etc.

  •   Usable with ordinary solder
    It is best to use only unleaded solder but unleaded solder may 

also be added to ordinary solder.

On repairing CD section, playing a disc without the CD lid, use 
Chuck Plate Jig.
  •  Code number of Chuck Plate Jig: X-4918-255-1