ICF-CD7000 - Sony Audio Service Manual (repair manual). Page 4

4

This section is extracted from
instruction manual.

Press TIMEZONE repeatedly to select the 
number as follows:

US and Canadian models:

1

Atrantic standard Time

2 (default 
setting)

Eastern standard Time

3

Central standard Time

4

Mountain standard Time

5

6

Yukon  standard  Time

7

Hawaian standard Time

Pacific standartd Time

few seconds and then the display returns to the 

The area number appears in the display for a

current time.  

to check the area number.

After the current time reappears, press TIMEZONE

discrepancies may arise during transport or storage.  If 
necessary, set the clock to the correct time by referring 

Though the clock is correctly set at the factory,

to “Setting the Clock Manually”.

time (summer time).

This model automatically adjust for daylight saving

“ ”is displayed from the beginning of daylight saving  
time (summer time) and disappears at the end of the 
daylight saving time (summer time) automatically.

AM on the second Sunday of March.

Sunday of November.

• Standard time begins at: 2:00 AM on the first

Plug in the unit.

Hold down CLOCK/DATE until a short beep 
sounds.

The year starts to flash on the display.

Press TUNE•TIME SET + or – repeatedly to 
set the year.

Press CLOCK/DATE.

Repeat steps 3 and 4 to set the month, 
the day, hour, and minute, and then press 
CLOCK/DATE.

Two short beeps sound and the seconds start 
incrementing from zero.

•ALARM-RESET while setting the clock.

• If you do not press a button for about 1 minute while 

setting the clock, the clock setting will be cancelled.

• The clock setting will be cancelled if you press OFF

Press CLOCK/DATE once for the date, and within 2 
seconds press it again for the year.

and then changes back to the current time.

The display shows the date or year for about 4 seconds

Hold down OFF

•ALARM-RESET and

until two short beeps sound.

“ ”is displayed, “On” appear for a few seconds,  
and then the time changes to daylight saving time 
(summer time).
To deactivate the daylight saving time (summer time) 

function, hold down OFF

•ALARM-RESET and

until two short beeps sound again. 

“OFF” appears for a few seconds, and then “

”

disappears.

Note
When replacing the battery, do not disconnect AC 
plug from AC outlet.
If you do, the current time, alarm and NAP timer will 
be initialized.

remove the battery to avoid undue battery discharge 

If the unit is to be left unplugged for a long time,

and damage to the unit from battery leakage.

• Dispose of the used battery promptly. Keep the 

lithium battery out of the reach of children. 
Should the battery be swallowed, consult a doctor 
immediately.

• Wipe the battery with a dry cloth to assure a good 

contact.

• Be sure to observe correct polarity when installing 

the battery.

• Do not hold the battery with metallic tweezers, 

otherwise a short-circuit may occur.

• Do not expose the battery to excessive heat such as 

direct sunlight, fire or the like.

incorrectly replaced.

There is a danger of explosion if the battery is

Replace only with the same or equivalent type 
recommended by the equipment manufacturer.

Standard Time) at the factory, and is powered by the 

This unit is preset to the current EST (Eastern

just plug it in, select your time zone.

back up battery. All you need to do the first time is

Plug in the unit.

in the display.

The current EST (Eastern Standard Time) appears

Press TIMEZONE.

Area number “2” appear in the display.

VOLUME +/–

SNOOZE /BRIGHTNESS

To keep good time, this unit contains one CR2032 
battery inside of the unit as a backup power source.
The battery keeps the clock operating in the event of a
power interruption.

When the battery becomes weak, “

”appears in the  

display.
If a power interruption occurs while the battery is 
weak, the current time and alarm will be initialized.
Replace the battery with a Sony CR2032 lithium 
battery. Use of another battery may cause a fire or
explosion.

the battery may be weak. In this case, consult your 
Sony dealer.

If “AM 12:00” (US and Canadian models) or “0:00” 
(Italian, Russian models) flashes in the display when 
the unit is connected to AC outlet for the first time, 

Keep the AC plug connected to the AC 
outlet and use a screwdriver to remove the 
screw that secures the battery holder at the 
bottom of the unit. (See Fig. 

-

)

Push the exhausted battery out from the 
bottom of the battery holder and insert a 
new battery with the 

 side facing up. (See 

Fig. 

-

)

Insert the battery holder back into the unit 
and secure it with the screw. (See Fig.  -

)

Press RADIO ON•BAND to turn “      ” off in
the display.

1 (default 
setting)

Central European Time/ 
Central European Summer 
Time

2

Eastern European Time/ 
Eastern European Summer 
Time

0

Western European Time/ 
Western European Summer 
Time

The area number appears in the display for a 
few seconds and then the display returns to the 
current time.  
After the current time reappears, press TIMEZONE 
to check the area number.

Note
Though the clock is correctly set at the factory, 
discrepancies may arise during transport or storage.  If 
necessary, set the clock to the correct time by referring 
to “Setting the Clock Manually”.

This model automatically adjusts for daylight saving 
time (summer time).
“ ” is displayed from the beginning of daylight saving 
time (summer time) and disappears at the end of the 
daylight saving time (summer time) automatically.
The summer time adjustment is based on GMT 
(Greenwich Mean Time).

• Daylight saving time (summer time) begins at: 1:00 

AM on the final Sunday of March.

• Standard time begins at: 2:00 AM on the final 

Sunday of October.

• Daylight saving time (summer time) begins at: 2:00 

AM on the final Sunday of March.

• Standard time begins at: 3:00 AM on the final 

Sunday of October.

• Daylight saving time (summer time) begins at: 3:00 

AM on the final Sunday of March.

• Standard time begins at: 4:00 AM on the final 

Sunday of October.

Italian, Russian models:

This unit is preset to the current date and time at the 
factory, and is powered by the back up battery.  All you 
need to do the first time is just plug it in, select your 
time zone.

 

Plug in the unit.

The  current CET (Central European Time) 
appears in the display.

 

Press

 TIMEZONE.

Area number “1” appear in the display.

 

Press

 TIMEZONE 

repeatedly to select the 

number as follows:

• Daylight saving time (summer time) begins at: 2:00