Read Sony HT-XT3 Service Manual online
HT-XT3
REVISION HISTORY
Ver.
Date
Description of Revision
1.0
2015.03
New
1.1
2015.06
Add “
9
” mark for all MB-1408 BOARD, COMPLETE (for SERVICE) in page 81.
Add “*” mark for Ref. No. 102 and 152 in page 80, 81 and 91.
Add and change illustrations in page 16, 17 and 80.
Add CLAMP in page 80 and 91.
Add CORE, FERRITE in page 80 and 91.
Add DOUBLE ADHESIVE TAPE (NFC) in page 80.
Add ELEMENT, ORGANIC EL INDICATOR in page 80.
Add FOOT in page 80.
Add FRONT SPK CABINET ASSY (SVX) in page 80.
Add TAPE, OLED in page 80.
Change P/N of MANUAL, INSTRUCTION in ACCESSORIES section in page 91.
Change P/N of REGULATOR, SWITCHING (3L405W) in page 81 and 91.
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
, follow the procedure below.
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.