HT-RT5 - Sony Audio Service Manual (repair manual). Page 7

6.  Select “Reset to Factory Default Settings”, and press the [

] 

button on the remote commander.

Setup

Reset to Factory Default Settings

Restor each setting to the factory setting.

Initialize Personal Information

7. Press 

the 

[

V]/[v] buttons on the remote commander to select 

the “All Settings”, and press the [ ] button on the remote com-
mander.

Reset to Factory Default Settings

Audio Settings
Bluetooth Settings
System Settings
Input Skip Settings
Network Settings
All Settings

8. Press 

the 

[

B]/[b] buttons on the remote commander to select 

the “Start”, and press the [ ] button on the remote commander.

All Settings

Restore all settings to the factory default
settings. The system will turn off after
reset.

Start

Cancel

9.  Turn the power off automatically, and initialization ends.

NOTICE  OF  MAC  ADDRESS  CHANGE  TO  CUSTOM-
ERS
When the complete MB-1414 board or card WLAN/BT combo is 
replaced, the MAC address has been changed.
Print the following explanations, and pass it to the customer with 
the repaired unit when you return the customer repaired unit.

Note of the MAC address change:
The MAC address of this unit was changed along with this repair.
Please set it again if you are using the MAC address fi ltering function 
of access point device of connection destination.
MAC address can be confi rmed from the settings menu screen of this 
unit. Please refer to the “Settings and Adjustment” of Operating In-
structions for details.

NOTES  ON  THE  WIRELESS  CONNECTION (LINK)  AF-
TER   REPAIRS  ARE  COMPLETE
When the following replacing repair is performed, the link of the 
Bar speaker (SA-RT5), Subwoofer (SA-WRT5) and Surround 
speaker (SA-SLRT5/SRRT5) is cut.
Return the Bar speaker (SA-RT5), Subwoofer (SA-WRT5) and 
Surround speaker (SA-SLRT5/SRRT5) to the customer after per-
forming the link according to the following procedure.

Parts in which the LINK will be disconnected due to replacement:
• 

Complete MB-1414 board

Link method:
When you turn on the Bar speaker (SA-RT5), Subwoofer (SA-
WRT5) and Surround speaker (SA-SLRT5/SRRT5), and then au-
tomatically link.
If do not automatically link, there is a possibility that the customer 
is perform the secure link. In that case, perform the following pro-
cedure.

Press SECURE LINK on the rear of 
the subwoofer and the surround 
speakers until the indicator turns 
orange.
Proceed to the next step within a few 
minutes.

Select [Start].
To return to the previous display, 
select [Cancel].

If the message [Cannot set Secure 
Link.] appears, follow the on-screen 
instructions.

Note: If customer had perform a secure link, only the Bar speaker is 

brought in for repair and the complete MB-1414 board is replaced, 
be sure to inform the customer when returning the repaired products 
that the customer must secure link again the Bar speaker, Subwoofer 
and Surround speaker.

 

  (Indicate that the secure link procedure is described in the operating 

instructions)