Read Sony HCD-SHAKEX3 / HCD-SHAKEX7 Service Manual online
HCD-SHAKEX1/SHAKEX3/SHAKEX7
How to search for a contact point of signal lines or the like in DIAGRAMS SECTION
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
If a contact point of a BLOCK DIAGRAM, PRINTED WIRING BOARD or SCHEMATIC DIAGRAM is shown in a different page, use
the PDF fi le search function to fi nd one.
e.g.) If a contact point is shown as
, follow the procedure below.
Procedure:
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
1. Press the [F] key while pressing the [Ctrl] key.
2. Input “>001Z” in the search box and press the [Enter] key.
3. The relevant part (page), where the contact point is shown, appears.
Note: If you still see the original page, press the [Enter] key again.
Ver.
Date
Description of Revision
Change P/N of CN101 and CN601 in MOTHERBOARD board.
Change P/N of L1001, L1003, L1006 and L1008 in 4CH DAMP board.
Change P/N of Ref. No. 153 in page 73.
Change P/N of Ref. No. 259 in page 75.
Delete CN451 in MOTHERBOARD board for Electrical Part List section (Service code changed).
Delete CORE, FERRITE for 220 – 240 V AC area in E model, Argentina, Latin- American and Thai
models in page 74 and 93.
Delete eight SCREW (+BVTP 3X8) in page 73.
Delete illustration of LENS (L) and LENS (R) in page 73.
Delete two SCREW (+BVTP2.6 (3CR)) in page 75.
Delete two SCREW (+BVTP 3X8) in page 11, 15, 71, 74 and 75.