Read Sony HCD-LS1 Service Manual online
9
(1) MODE-1
EJECT, DISC LOAD state
(2) MODE-2
STANDARD State (STOP state)
(3) MODE-3
PLAY, DISC CHANGE state
When disassembling and reassembling the mechanism deck by any failure, the mechanism deck must be in (2) Standard
state (STOP state) as shown below.
• The mechanism deck (HG-1) has three modes. (Fig. A)
state (STOP state) as shown below.
• The mechanism deck (HG-1) has three modes. (Fig. A)
mecha UD sub cam SL
Traverse Mecha Down state
Traverse Mecha Up state
sus base X sub ass’y shaft
(Fig. A)
HOW TO ADJUST STOP STATE POSITION
D lock sleeve SL
emergency gear SL
2
Rotate gradually the emergency
gear SL in the up arrow direction
up to the position where the D lock
sleeve SL comes to the bottom.
(To attain (2) standard state in Fig. A)
gear SL in the up arrow direction
up to the position where the D lock
sleeve SL comes to the bottom.
(To attain (2) standard state in Fig. A)
1
Rotate fully the emergency gear SL
in the down arrow direction.
in the down arrow direction.
HOLDER MECHA, DUST SEAL EMA SL
PRECAUTIONS ON DISASSEMBLING AND REASSEMBLING MECHANISM DECK
1
four screws
(B3
(B3
×
5)
2
holder mecha
3
dust seal EMA SL
Note: Carefully remove it since
it is used again later.
1
four screws
(B3
(B3
×
5)
2
holder mecha
Click on the first or last page to see other HCD-LS1 service manuals if exist.