Read Sony HCD-G2500 / HCD-XB20 / HCD-XB22 / LBT-G2500 / LBT-XB20 / LBT-XB22 Service Manual online
— 14 —
FM Tuned Level Adjustment
set
Procedure:
1.
1.
Supply a 28 dB 98 MHz signal from the ANTENNA terminal.
2.
Tune the set to 98 MHz.
3.
Adjust SFR101 to the point (moment) when the TUNED
indicator will change from going off to going on.
indicator will change from going off to going on.
Adjustment Location: MAIN board
FM Tracking Adjustment
(US, Australian, Mexican model)
(US, Australian, Mexican model)
Procedure:
1.
Tune the set to 90 MHz.
2.
Adjust L102 so that when the waveform on the oscilloscope is
maximum, no noise appears.
maximum, no noise appears.
3.
Tune the set to 106 MHz.
4.
Adjust TC101 so that when the waveform on the oscilloscope
is maximum, no noise appears.
is maximum, no noise appears.
• Repeat the procedures in each adjustment several times, and the
tracking adjustment should be finally done by the trimmer
capacitors.
capacitors.
Adjustment Location: MAIN board
Adjustment Location
[MAIN BOARD] — Component side —
Carrier frequency : 90 MHz, 106 MHz
Modulation
Modulation
: AUDIO 1kHz, 75kHz deviation (100%)
Output level
: 20 dB (at 75
Ω
open)
FM RF SSG
Carrier frequency : 98 MHz
Modulation
Modulation
: AUDIO 1 kHz, 75 kHz
deviation (100%)
Output level
: 28 dB (at 75
Ω
open)
FM ANTENNA terminal
(JK101)
(JK101)
75
Ω
coaxial
FM ANTENNA terminal (JK101)
SPEAKER terminal (JK703)
FM RF SSG
set
oscilloscope
JK101
L105
TC102
L104
IC301
L102
L103
TC101
SFR101
IC103
(AM
Tracking)
Tracking)
(AM Tuning
Voltage)
Voltage)
(FM Tuning
Voltage)
Voltage)
(FM
Tracking)
Tracking)
(FM Tuned Level)
SFR809
(Tape speed)
(Tape speed)
Click on the first or last page to see other HCD-G2500 / HCD-XB20 / HCD-XB22 / LBT-G2500 / LBT-XB20 / LBT-XB22 service manuals if exist.