HBD-EF1100 - Sony Audio Service Manual (repair manual). Page 11

CHECKING  METHOD  OF  NETWORK  OPERATION
It is necessary to check the network operation, when replacing the 
MB1002 board. Check the operation of wireless and wired LAN, 
according to the following method.

1.  Checking Method of Wireless LAN Operation
Check that access point is recognized surely.

Necessary Equipment:
Wireless access point with router function (AP)

1.  Press the [HOME] button on the remote commander to enter 

the home menu.

2.  Press the [m]/[M]/[<]/[,] buttons on the remote command-

er to select “Network Settings”

“Internet Settings”, and press 

the [ ] button on the remote commander.

3.  Press the [m]/[M] buttons on the remote commander to select 

“Wireless Setup (built-in)”, and press the [ ] button on the 
remote commander.

4.  The system starts searching for access points, and displays a 

list of up available network name (SSID).

5.  Check that access point (SSID) is displayed on the searching 

result.

Note: Refer to the instruction manual about details of the setting method.

2.  Checking method of wired LAN operation
Check that access point is recognized surely.

1.  Connect the main unit to the router or the hub, etc. with the 

LAN cable.

2.  Press the [HOME] button on the remote commander to enter 

the home menu.

3. Press 

the 

[m]/[M]/[<]/[,] buttons on the remote command-

er to select “Network Settings”

“Internet Settings”, and press 

the [ ] button on the remote commander.

4.  Press the [m]/[M] buttons on the remote commander to select 

“Wired Setup”, and press the [ ] button on the remote com-
mander.

5.  Press the [m]/[M] buttons on the remote commander to select 

“Auto”, and press the [ ] button on the remote commander.

6.  Press the [,] button on the remote commander.

7.  Press the [m]/[M] buttons on the remote commander to select 

“Save & Connect”, and press the [ ] button on the remote 
commander.

8.  When “Internet Settings is now complete.” appears, then press 

the [ ] button on the remote commander.

9.  Press the [HOME] button on the remote commander to enter 

the home menu.

10. Press the [m]/[M]/[<]/[,] buttons on the remote command-

er to select “Network Settings”

“Network Connection Diag-

nostics”, and press the [ ] button on the remote commander.

11. Press the [<]/[,] buttons on the remote commander to 

select “IPV4” or “IPV6”, and press the [ ] button on the 
remote commander. 

12. Check that IP address can be acquired.

Note: Refer to the instruction manual about details of the setting method.