Read Sony DHC-FLX9W / HCD-FLX9W Service Manual online
2
HCD-FLX9W
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure.
other than those specified herein may result in hazardous radiation
exposure.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE
WITH MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
a CLASS 1 LASER product.
The CLASS 1 LASER
PRODUCT MARKING is
located on the rear exterior.
AM tuner section
Tuning range
Saudi Arabian model:
Saudi Arabian model:
531
− 1,602 kHz
(with the tuning interval
set at 9 kHz)
set at 9 kHz)
Other models:
530
− 1,710 kHz
(with the tuning interval
set at 10 kHz)
531
set at 10 kHz)
531
− 1,602 kHz
(with the tuning interval
set at 9 kHz)
set at 9 kHz)
Antenna
Antenna terminals
Antenna terminals
External antenna terminal
Intermediate frequency
450 kHz
AM loop antenna
General
Power requirements
Saudi Arabian model:
Saudi Arabian model:
120
− 127 V, 220 V or
230
− 240 V AC,
50/60 Hz
Adjustable with voltage
selector
Adjustable with voltage
selector
Thailand model:
220 V AC, 50/60 Hz
Other models:
120 V, 220 V or
230
230
− 240 V AC,
50/60 Hz
Adjustable with voltage
selector
Adjustable with voltage
selector
Power consumption
425 watts
Dimensions (w/h/d)
Approx. 235
× 435 ×
420 mm
Mass
Approx. 15.2 kg
Design and specifications are subject to change
without notice.
without notice.
FM tuner section
Tuning range
87.5
− 108.0 MHz
(50-kHz step)
Antenna
Antenna terminals
Antenna terminals
75 ohm unbalanced
Intermediate frequency
10.7 MHz
FM lead antenna
Signal-to-noise ratio
More than 90 dB
Dynamic range
More than 90 dB
Video color system format
NTSC, PAL
OPTICAL DIGITAL OUT (Square optical connector
jack, rear panel)
wavelength
jack, rear panel)
wavelength
660 nm
Tape player section
Recording system
4-track 2-channel stereo
Frequency response
50
− 13,000 Hz (±3 dB),
using Sony TYPE I
cassette
cassette
Tuner section
FM stereo, FM/AM superheterodyne tuner
Click on the first or last page to see other DHC-FLX9W / HCD-FLX9W service manuals if exist.