Read Sony DAV-X10 / HCD-X10 Service Manual online
8
HCD-X10
3
Open the tray.
1
2
flat head screw driver
– Bottom view –
Connect jig (extension cable J-2501-242-A)
DISPLAY board (CN801) and MAIN board (CN507).
DISPLAY board (CN801) and MAIN board (CN507).
DISPLAY board
MAIN board
AV board
insulating sheet
CD mechanism deck
wire (flat type) (24 core)
Note 2: Do not remove the wire (flat type) (24 core) (CN1102).
If you remove the wire (flat type) (24 core) (CN1102),
solder the bridge of optical pick-up before removing.
solder the bridge of optical pick-up before removing.
Note 1: The jig (extension cable J-2501-242-A) connected between
the CN507 on the MAIN board and the CN801
on the DISPLAY board can be used only by TYPE-12.
Never use this jig in TYPE-11.
When the jig (extension cable J-2501-242-A) is used
by TYPE-11, the set is damaged.
on the DISPLAY board can be used only by TYPE-12.
Never use this jig in TYPE-11.
When the jig (extension cable J-2501-242-A) is used
by TYPE-11, the set is damaged.
Note:
Follow the disassembly procedure in the numerical order given.
HOW TO OPEN THE TRAY WHEN POWER SWITCH TURNS OFF
MAIN BOARD SERVICE POSITION
•
In checking the MAIN board (TYPE-12), prepare the extension jig
(Part No. J-2501-242-A: 1.00 mm Pitch, 11 cores, Length 300 mm)
(Part No. J-2501-242-A: 1.00 mm Pitch, 11 cores, Length 300 mm)
Click on the first or last page to see other DAV-X10 / HCD-X10 service manuals if exist.