Read Sony DAR-RH1000 / DAR-RH7000 / SA-WSRH1 / SA-WSRH10 / SS-CT7000 / SS-TS7000 / SS-TS7001 Service Manual online
3
SA-WSRH1/WSRH10/SS-CT7000/TS7000/TS7001
SECTION 1
SERVICING NOTES
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
•
Unleaded solder melts at a temperature about 40 ˚C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 ˚C.
Caution: The printed pattern (copper foil) may peel away if
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
•
Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
This set doesn’t work if it doesn’t connect it with the main unit.
When it is necessary to operate this set, connect it with the main
unit.
When it is necessary to operate this set, connect it with the main
unit.
Click on the first or last page to see other DAR-RH1000 / DAR-RH7000 / SA-WSRH1 / SA-WSRH10 / SS-CT7000 / SS-TS7000 / SS-TS7001 service manuals if exist.