CMT-DH70SWR, SA-WDH70SWR - Sony Audio Service Manual (repair manual). Page 6

Read Sony CMT-DH70SWR / SA-WDH70SWR Service Manual online

SA-WDH70SWR
6
SECTION  3
DIAGRAMS
For Schematic Diagrams.
Note:
•  All capacitors are in μF unless otherwise noted. (p: pF) 50 
WV or less are not indicated except for electrolytics and 
tantalums.
•  All resistors are in Ω and 1/4 W or less unless otherwise 
specifi ed.
•  2 : Nonfl ammable resistor.
•  C : Panel designation.
THIS  NOTE  IS  COMMON  FOR  PRINTED  WIRING  BOARDS  AND  SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
•  A : B+ Line.
•  B : B– Line.
•  Voltages are dc with respect to ground under no-signal 
conditions.
  no mark : POWER ON
•  Voltages are taken with VOM (Input impedance 10 M
Ω).
  Voltage variations may be noted due to normal production 
tolerances.
• Signal path.
  F : 
AUDIO
For Printed Wiring Boards.
Note:
•  X : Parts extracted from the component side.
•  Y : Parts extracted from the conductor side.
• 
 : Pattern from the side which enables seeing.
  (The other layers’ patterns are not indicated.)
•  Indication of transistor.
 
C
B
These are omitted. 
E
Q
 
B
These are omitted.
C E
Q
Note: The components identifi ed by mark 0 or dotted 
line with mark 0 are critical for safety. 
 
Replace only with part number specifi ed.
Caution:
Pattern face side:
(Conductor Side)
Parts face side: 
(Component Side)
Parts on the pattern face side seen 
from the pattern face are indicated.
Parts on the parts face side seen from 
the parts face are indicated.
•  IC Block Diagram
– AMP Board –
IC125  STK404-130S
2
3 4
5
6 7
8 9
10 11
12 13
POSI
SW
-IN
SW
-NF
SUB
-PRE
+PRE
BIAS+
BIAS-
-VCC
+VSS
-RE
+RE
1
POSI
Page of 18
Display

Click on the first or last page to see other CMT-DH70SWR / SA-WDH70SWR service manuals if exist.