Read Sony CMT-DH70SWR / SA-WDH70SWR Service Manual online
SA-WDH70SWR
2
SECTION 1
SERVICING NOTES
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong
viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
also be added to ordinary solder.
ADVANCE PREPARATION WHEN CONFIRMING OP-
ERATION
When the operation of the SA-WDH70SWR is confi rmed, it is
necessary to connect the HCD-DH70SWR.
Confi rm the HCD-DH70SWR and SA-WDH70SWR are prepared
beforehand when you repair.
ERATION
When the operation of the SA-WDH70SWR is confi rmed, it is
necessary to connect the HCD-DH70SWR.
Confi rm the HCD-DH70SWR and SA-WDH70SWR are prepared
beforehand when you repair.
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitors (C156 and
C157) to discharge the capacitors (C156 and C157).
When checking the board, for the electric shock prevention, con-
nect the resistors to both ends of respective capacitors (C156 and
C157) to discharge the capacitors (C156 and C157).
C157
C156
800
:/2 W
800
:/2 W
– AMP Board (Conductor Side) –
Click on the first or last page to see other CMT-DH70SWR / SA-WDH70SWR service manuals if exist.