CDP-CX260 - Sony Audio Service Manual (repair manual). Page 18

– 18 –

(1) Rotate the cam and adjust to the

position shown in the figure.

Perform this adjustment after the “holder (disc A) adjustment”.
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.

(2) Check that the lever (stopper) assembly

secures the disc table as shown in the figure.

(3) Loosen the fixed screw by 60

°

 to 90

°

, and use a tapering screwdriver to adjust the screw as shown in the figure.

Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green) is
switched to the pause button's LED (orange) (or its reverse).

The LED may not light up in steps (3) and (4) for some
microprocessor versions, and consequently adjustments will not
be possible.
In this case, fix the bracket (sensor) at the mechanical center.
As fine adjustments need to be performed in “Disc Sensor
Adjustment” in Electrical Adjustments, sensor alignment need
not be performed here.

(4) Moving the disc table right and left with a hand after the screw

is fixed, the table will move by the play of a disc table. If the
LEDs light up alternately, the adjustment will be performed
correctly.

Cam

Cam

Bracket (sensor)

Table assembly

Swing

PAUSE button

PLAY button

Disc table

Lever (stopper) assembly

Tapering screwdriver

Luminus board

Bracket (sensor)

Fixed screw

Lever (stopper)
assembly