VC-MH834 (serv.man12). Operation manual page 7 to end - Sharp VCR User Guide / Operation Manual. Page 7

 

9

 

Press[

/

]to select SAT NO. 

•

 

If you wish to install a Sky Digital receiver enter the code 

 

, once the arrows on the 

screen have moved from VCR to SAT your Sky Digibox should change to channel 501. 

•

 

Refer to the table at the end of this manual. Look for the make of your satellite receiver 
and use the

 

 to enter the first code number listed. For example 

number 8 should be entered 0 0 8. Your satellite should now change to preset channel 12.

 

Once your Satellite Receiver has responded to the 
VCR by changing channel, press the 

 

 

button to continue. 

The VCR will attempt to copy the TV preset list 
(NexTView, Smart Link, Easy Link and Megalogic 
compatible TV’s only). During the copying process 
the display will show the TV presets that are being 
copied. If the VCR is unable to copy the TV preset list 
the terrestrial and satellite channels will be 
automatically installed. (Auto install may take a few 
minutes.) 

 

• If your satellite receiver has not changed to preset channel 12 enter the next code 

number on the list. Continue until the receiver shows preset channel 12, then continue 
from point 13.

• If your satellite receiver is not in the manufacturers list or after entering all the numbers 

listed for your receiver, the receiver preset channel has still not changed to 12, enter 

 

and check your receiver. If it has not changed press 

 to select

 

 and re-check. If it 

has changed continue from point 13.

• If there is still no response, try adjusting the position of your satellite receiver.

If you connect a Satellite Receiver to the VCR for the first time, after auto-installation 
or you are replacing your existing Satellite Receiver, you will need to perform a 
complete Auto Installation Procedure to re-tune your VCR. (Refer to 

.)

TINS-3987UMZZ ENGLISH.book  Page 9  Thursday, April 26, 2001  3:01 PM