VC-MH731HM (serv.man10). Operation manual - Sharp VCR User Guide / Operation Manual. Page 38

34

The VCR has 84 programmable channel positions each of which can be set to any of the
broadcast channels. 

IMPORTANT NOTE:
10. Press [

] to select DECODER. This is preset to OFF. If you wish to connect a 

satellite receiver to the VCR as shown previously, leave this set to OFF. If you wish to 
connect a decoder use [ ] 

to turn the decoder function ON.

/

/

11. Press [

] to select SKIP.

The SKIP function determines whether the channel can be selected when using 
CHANNEL [

/

] instead of the NUMBER BUTTONS.

12. Press [

] to select ON or OFF for this option. Press SET to confirm.

13. Press MENU to leave this function.

/

/

If you wish to connect a satellite receiver / cable box  to your VCR 

after auto-

installation it is not necessary to completely re-install all channels. The installation procedure

for cable boxes is the same as for satellite receivers. Sharp cannot guarantee this feature will
operate with all makes of satellite receiver or cable box. (See end of this manual for manufacturers
codes.)
Follow the procedure below:
1.Press MENU.
2.Press [

] to select SET UP. Press SET to confirm.

3.CHANNEL PRESET will be highlighted. Press SET to confirm.

/

4.Press [

] to select SAT RECEIVER.

Press SET to confirm. The satellite receiver
screen will appear.  

5.Follow points 5-11 in Auto Installation.

(Satelitte/Cable Box control only).

6.Then press [

] to select SAT

PROGRAM SEARCH. Press SET to confirm.
The satellite channels will be installed.
(This may take a few minutes)

7.Then press MENU.

/

/

● 

On leaving this menu, the VCR will attempt to transfer the channel information to a

NexTView, Smart Link, Easy Link or Megalogic compatible TV. Please wait for the VCR to
complete this operation. (Refer to your TV operation manual for more information).

vc-m331/mh731hm  3/2/99 1:35 pm  Page 38