Read Sharp VC-ME80HM Service Manual online
11
VC-ME80GM
VC-ME80HM
VC-ME80HM
Figure 4-1.
• Reassembly
1. Before installing the cassette housing control, short-
1. Before installing the cassette housing control, short-
circuit P811 provided at the center (when facing to the
main PWB), press the EJECT button. The casecon drive
gear turns and stops when the positioning mark ap-
pears. Engage two teeth of casecon drive gear with the
three teeth of casecon drive angle gear, and set on the
mechanism chassis as shown below.
main PWB), press the EJECT button. The casecon drive
gear turns and stops when the positioning mark ap-
pears. Engage two teeth of casecon drive gear with the
three teeth of casecon drive angle gear, and set on the
mechanism chassis as shown below.
Figure 4-2.
2. Install in the reverse order of removal.
Notes:
1. When fitting the S/E sensor holder to the cassette
1. When fitting the S/E sensor holder to the cassette
controller frame L/R, take care.
2. Misengagement of teeth of casecon drive gear and drive
angle gear causes malfunction. (The cassette cannot be
set, load and ejection are repeated).
set, load and ejection are repeated).
3. In the case when you use the magnet screw driver, never
approach the magnet driver to the A/C head, FE head,
and drum.
and drum.
4. When installing or removing, take care so that the
cassette housing control and tool do not contact the
guide pin or drum.
guide pin or drum.
5. After installing the cassette housing control once per-
form cassette loading operation.
TO RUN A TAPE WITHOUT THE CASSETTE
HOUSING CONTROL ASSEMBLY
HOUSING CONTROL ASSEMBLY
1. Remove the full-surface panel.
2. Short-circuit P811.
3. Plug in the power cord.
4. Turn off the power switch.
2. Short-circuit P811.
3. Plug in the power cord.
4. Turn off the power switch.
(The pole bases move into U.L.position.)
5. Open the lid of a cassette tape by hand.
6. Hold the lid with two pieces of vinyl tape.
7. Set the cassette tape in the mechanism chassis.
8. Stabilize the cassette tape with a weight (500g) to
6. Hold the lid with two pieces of vinyl tape.
7. Set the cassette tape in the mechanism chassis.
8. Stabilize the cassette tape with a weight (500g) to
prevent floating.
9. Turn on the power switch.
10. Perform running test.
10. Perform running test.
REMOVING AND INSTALLING THE CASSETTE
HOUSING
HOUSING
• Removal
1. In the cassette removing mode remove the cassette.
2. Unplug the power cord.
3. Remove in the following numerical order.
1. In the cassette removing mode remove the cassette.
2. Unplug the power cord.
3. Remove in the following numerical order.
a) Remove two screws
1
.
b) Slide and pull up the cassette housing control.
1
Casecon
drive gear
drive gear
Casecon drive
angle gear
angle gear
500g
Figure 4-3.
Mechanism chassis
Weight to prevent
float (500g)
float (500g)
Note:
The weight should not be more than 500g.
The weight should not be more than 500g.
To take out the cassette tape.
1. Turn off the power switch.
2. Take out the cassette tape.
1. Turn off the power switch.
2. Take out the cassette tape.
Click on the first or last page to see other VC-ME80HM service manuals if exist.