VC-ME80HM (serv.man7). Operation manual - Sharp VCR User Guide / Operation Manual. Page 9

9

9. Press [

]  to select SAT NO. Turn to the table at the end of this manual. Look for 

the make of  your satellite receiver and use the NUMBER BUTTONS to enter the first 
code number listed. For example number 8 should be entered 0 0 8. Your satellite 
should now change to preset channel 12.

10.If your satellite receiver has changed to preset channel 12,  press SET to 

confirm the VCR will automatically install both satellite and terrestrial channels. (This may
take a few minutes).

11.The VCR will attempt to copy the TV preset list (NexTView, Smart Link, Easy Link and

Megalogic compatible TV’s only). During the copying process the display will show the
TV presets that are being copied. If the VCR is unable to copy the TV preset list the
terrestrial and satellite channels will be automatically installed. (Auto install may take a
few minutes.)  On completion the MOVE menu will appear showing the preset channel
order. Press MENU to exit. If the clock is not automatically set, the clock screen will
appear, refer to MANUALLY SETTING THE CLOCK. To check the clock has been set
correctly, press DISPLAY until the time appears on the display. If you wish to customise
the channel order refer to MANUALLY SORTING CHANNELS.

/

If you connect a satellite receiver to the VCR 

for the first time,

after auto-installation, see

SATELLITE RECEIVER / CABLE BOX INSTALLATION.

If you 

replace

your satellite receiver, you will need to follow the 

complete

auto-

installation procedure to tune your VCR to the satellite receiver. This is because your 
new satellite receiver will not over-write the previous satellite channels in your VCR.

●

If your satellite receiver has not changed to preset channel 12 enter the next code 
number on the list. Continue until the receiver shows preset channel 12, then continue
from point 10.

●

If your satellite receiver is not listed at the end of this manual or after entering all the
numbers listed for your receiver, the satellite receiver preset channel has still not changed
to 12, enter  0 0 1, and look to see if the satellite receiver has changed to preset
channel 12. If it has, continue from point 10. If not, press 

to select 0 0 2 and re-

check. Continue until your receiver changes to preset 12, then continue from point 10.

●

If there is still no response from your satellite receiver, try adjusting its position to
improve the Infa Red VCR to satellite receiver reception.

●

Auto-installation will stop when the satellite receiver reaches preset channel 99, or when
all the 84 VCR preset channels have been used.

●

The VCR will place all found terrestrial channels starting at preset 1, then all satellite
channels from the first available preset channel after the terrestrial channels.

ME-80 HM   7/12/98 12:15 pm  Page 9