LC-46LE831E (serv.man15). Adjustment - Sharp TV Service Manual (repair manual). Page 10

LC-40/46LE830E, RU/831E, S

5 – 10

5. Operation after “RESET”

Select “RESET” in the PUBLIC Mode, and it operates as follows when it is executed (refer to the basic operation).

• The set contents in the PUBLIC mode are initialized.

• It does not exit the PUBLIC mode.

• If “EXCUTE” is not executed, the content that does RESET is not reflected.

6. Setting items. (* Item names and selective items are expressed in English.)

1) Power ON fixed [POWER ON FIXED]

If the power button is pressed in the ordinary mode in setting to “FIXED_ALL” and “FIXED_BODYKEY”, the caution is displayed for 5 seconds.

* The OSD display is an example.

If another ODS is previously displayed, the status is reset (MENU or similar).

2) Instantaneous current shutdown setting in turning off the power [SHUT DOWN MODE]

3) Volume maximum level [MAXIMUM VOLUME]

Option

“VARIABLE”, “FIXED_ALL”, “FIXED_BODYKEY” or “RCRESPOND” (loop enabled)

Default “VARIABLE”
Function • VARIABLE

• FIXED_ALL
• FIXED_BODYKEY 
• RC RESPOND 

: “POWER/RECEPTION” key on TV unit or remote control is enabled.
: “POWER/RECEPTION” key on TV unit or remote control is disabled.
: Only the “MAIN POWER” key on TV unit is disabled (The remote control is enabled).
: The main unit’s POWER switch toggles between ON and Standby (the same operation by the 
  remote control).

Key disabled when set 
other than default

• OFF TIMER (SLEEP) (*Only when setting to FIXED_ALL)

Remarks 

• When selecting to “FIXED_ALL”, function related standby factors (see below) doesn’t work. and not selecting.

  OFF TIMER (Sleep)
  No operation OFF
  No signal OFF (including the power management)
* These items does not exist according to the model.

Option

“NORMAL” or “QUICK”

Default NORMAL
Function 

• This function decides whether scanning digital tuner is enabled or disabled when the power is standby.
     NORMAL
     QUICK

: Scanning digital tuner is enabled when the power is standby.
: Scanning digital tuner is disable.
  It is possible to put into the standby state instantaneously due to power off input, when the 
  power is standby.
  Immediately, state is a complete standby.

Remarks 

In selecting “QUICK”, the function does not work for the following items. (selection impossible.)
• ON TIMER, QUICK START, DIGITAL FIXED, etc.

* These items does not exist according to the model.

Option

0~60 (loop disabled)

Default 60
Function

The volume cannot be increased more than the adjusted value (the main unit’s speaker only).

Remarks 

• When setting to 59 or less, only the figure is displayed in the normal mode; the volume bar is not displayed.
• The volume of the headphones is limited.
• The setting is impossible when VOLUME FIXED is set to FIXED.

When power button on the main unit is pressed

When power button on R/C is pressed

No Power off by power button.

No Power off by remote control.