LC-46DH77E (serv.man4). Adjustment Procedure - Sharp TV Service Manual (repair manual). Page 5

LC-42DH77E/RU/S/V, LC-46DH77E/RU/S/V

3 – 5

1. NORMAL STANDBY CAUSE (Page 1/16)

Display of a cause (code) of the last standby.

The cause of the last standby is recorded in EEPROM whenever possible.

Checking this code will be useful in finding a problem when you repair the troubled set.

2. EEP SAVE (Page 16/16)

Storage of EEP adjustment value

3. EEP RECOVER (Page 16/16)

Retrieval of EEP adjustment value from storage area.

1. Function

This LCD colour TV set incorporates a lamp error detection feature that automatically turns off the power for safety under abnormal lamp or lamp
circuit conditions. If by any chance anything is wrong with the lamp or lamp circuit or if the lamp error detection feature is activated for some rea-
son, the following will result.

1) The power is interrupted in about 6 seconds after it is turned on.

(The power LED on the front of the TV set turns red from green and keeps blinking in red: ON for 300ms and OFF for 1500ms.).

2) If the above phenomenon 1) occurs 5 times consecutively, it becomes impossible to turn on the power. (The power LED remained red).

2. Measures

1) Checking with lamp error detection OFF

Enter the adjustment process mode, referring to 2. Entering and exiting the adjustment process mode.

If there is a problem with the lamp or lamp circuit, the lamp will go out. (The power LED is green.)

Then, you can check the operation to see if the lamp and lamp circuit are in trouble.

2) Resetting the lamp error count

After the lamp and lamp circuit are found out of trouble, reset the lamp error count. If a lamp error is detected five consecutive times, the power
cannot be turned on. Using the cursor (

/

) key, move to the cursor to [LAMP ERROR RESET], Line 8 on adjustment process mode ser-

vice page 2/16. With the cursor (</>) keys, select the [LAMP ERROR RESET] value. Finally press the cursor (OK) eys to reset the value to “0”.

Table of contents of adjustment process mode Page 2/16

INDUSTRY INIT

Enter

INDUSTRY INIT(-Hotel)

OFF

HOTEL MODE

OFF
5H0M

Center Acutime
RESET

OFF

Backlight Acutime
RESET

OFF

LAMP ERROR RESET

OFF

ADJ PARAM SET

Enter

VIC XPOS

0

VIC YPOS

0

VIC SIGNAL TYPE

MAIN

VIC READ

OFF

Resetting to "0"