Read Sharp LC-37GD1E (serv.man25) User Guide / Operation Manual online
10
Preparation
Setting the Display on the wall
Setting the AVC System with the stand
CAUTION
• Installing the LCD Colour TV requires special skill that should only be performed by qualified service personnel.
Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting
or mounting that results in accident or injury.
or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the Display
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket. (See the bracket instructions for details.)
How to install the AVC System vertically using the stand unit.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
NOTE
• When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when
standing up directly on the floor or a flat surface as this can result in equipment failure.
About setting the Display angle
• Angular mounting is not possible with the
speaker attached.
• You can set the Display on the wall up to 20
degrees forward when the speaker is not
attached. Do not set the angle outside this
range.
attached. Do not set the angle outside this
range.
1
Stick each spacer to the
stand as shown.
stand as shown.
Peel each spacer away from the paper
and attach to the four bulging areas
on the stand.
and attach to the four bulging areas
on the stand.
2
Attach each cushion to
the stand as shown.
the stand as shown.
3
Fit the stand to the AVC
System.
System.
Peel each cushion
away from the
paper and attach
to the four areas
at the bottom.
away from the
paper and attach
to the four areas
at the bottom.
Insert the stand into the AVC
System, making sure that the
thick and thin bulges of the
stand align with the big and
small holes on the AVC
System.
System, making sure that the
thick and thin bulges of the
stand align with the big and
small holes on the AVC
System.
Stand
spacer
spacer
Bulge
Stand cushion
Bulge
Hole
4
Attach the stand using the
stand screws as shown.
stand screws as shown.
Stand screw
The AVC System installed
vertically with the stand.
vertically with the stand.
Attaching point
Attaching point
Bulge
LC-32GD1E(E)-a
04.4.6, 1:35 PM
10
Click on the first or last page to see other LC-37GD1E (serv.man25) service manuals if exist.