LC-32LD166K (serv.man3) - Sharp TV Service Manual (repair manual). Page 12

LC-50LD264–LC-50LD265–LC-50LD265RU–LC-50LD266

 

9 

 

TV screen size (Inches) 

VESA-compatible wall bracket 

(millimeters) (W x H) 

Screw type(Metric) 

 

m

m

 

8

1

 

x

 

6

M

 

m

m

 

0

0

4

 

x

 

0

0

4

 "

0

5

 

 

 

1 Remove the battery compartment from the remote control. 
2 Insert two “ AAA”  size batteries (supplied with the product). 

 

• Place the batteries with their terminals corresponding to the (+) and (-) indications in the battery compartment. 

 

Caution 
Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below. 
• Do not mix batteries of different types. Different types of batteries have different characteristics. 
• Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical 

 leakage of old batteries. 

• Remove batteries as soon as they are worn out. Chemicals that leak from batteries come in contact with skin can cause 

 a rash. If you find any chemical leakage, wipe thoroughly with a cloth. 

• The batteries supplied with this product may have a shorter life expectancy due to storage conditions. 

• If you will not be using the remote control unit for an extended period of time, remove batteries from it. 
• The batteries (batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. 

 

LC-50LD264–LC-50LD265–LC-50LD265RU–LC-50LD266

 

8 

 

 

Note 
• Always use the AC cord supplied with the TV. 
• The illustrations above are for explanation purposes and may vary slightly from the actual accessories

 

• Before attaching (or detaching) the stand, unplug the AC cord from the AC IN terminal. 
• Before attaching (or detaching) the stand, spread a cushion under the TV to prevent it from being damaged. 
Caution 
• Attach the stand in the correct direction. 
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. 
1 Put the TV face down on a safe surface that is covered by a soft and smooth cloth. 
2 Adjust the TV stand to the bottom of the TV. 
3 Fasten the screws by using a cross-head screwdriver (Not supplied). 
Caution 
• To avoid damages, do not push too hard or put excessive pressure to the stand neck while turning the TV 

Note 
• To detach the stand, perform the steps in reverse order.