Read Sharp LC-32GD7E (serv.man5) User Guide / Operation Manual online
9
Cautions regarding the remote control unit
Do not expose the remote control unit
to shock.
In addition, do not expose the remote
control unit to liquids, and do not place
in an area with high humidity.
Do not install or place the remote con-
trol unit under direct sunlight. The heat
may cause deformation of the unit.
The remote control unit may not work
properly if the remote control sensor of
the TV is under direct sunlight or strong
lighting. In such case, change the angle
of the lighting or TV, or operate the
remote control unit closer to the remote
control sensor.
Connection
Power mains
Connect the TV set to a 220-240V/50–60 Hertz a power outlet. Plug the
small plug of the power cable into the mains socket on the back of the
TV, the large plug into a wall outlet.
Antenna
Connect the antenna cable from your antenna-/cable socket or the
(room-/roof) antenna for DVB-T with the antenna socket “IN VHF/UHF/
DVB-T” on the back of your TV set to receive digitally/terrestrially broad-
cast stations.
An indoor antenna can also be used under good reception conditions.
Passive and active room antennas are offered commercially. In an active
antenna its power is supplied via the antenna connection “VHF/UHF/DVB-
T”.
The supply voltage (5 Volt) must be correspondingly set in the “TV Menu
– Connections–– Antenna DVB –– Antenna DVB-T”.
It is advisable to use an antenna without directional characteristic. If the
location is outside the normal transmission range, a directional antenna
(Yagi) can also be used to improve the reception quality.
You can obtain more detailed information about receivable digital sta-
tions in your area from your dealer.
You can also receive an analogue cable station or an analogue terrestrial
station and a satellite station at the same time and watch with the picture
in picture (PIP) function.
•
•
•
Remote control
To insert or change the batteries press on the arrow. Slide the battery
compartment cover downwards and remove it. Insert Alkali Mangan
LR 03 (AAA) batteries and ensure that the + and – ends are connected
correctly .
Then push the cover back on from the bottom until it snaps in.
CAUTION
Improper use of batteries can result in chemical leakage or explosion. Be
sure to follow the instructions below.
Do not mix batteries of different types. Different types of batteries have
different characteristics.
Do not mix old and new batteries. Mixing old and new batteries can
shorten the life of new batteries or cause chemical
leakage in old batteries.
Remove batteries as soon as they have worn out. Chemicals that leak
from batteries can cause a rash. If you fi nd any
chemical leakage, wipe thoroughly with a cloth.
The batteries supplied with this product may have a shorter life
expectancy due to storage conditions.
If you will not be using the remote control unit for an extended period
of time, remove the batteries from it.
Using the remote control unit
Use the remote control unit by pointing it towards the remote control
sensor. Objects between the remote control unit and sensor may prevent
proper operation.
30
°
30
°
m
7
t
e
ef
3
2
•
•
•
•
•
•
•
•
•
First installation
Remote control sensor
Click on the first or last page to see other LC-32GD7E (serv.man5) service manuals if exist.