LC-32DH510E (serv.man2) - Sharp TV User Guide / Operation Manual. Page 9

When the TV is powered on for the first time after purchase, 
the initial auto installation wizard appears. Follow the menus 
and make the necessary settings one after another.

1  Press a on the TV.

The initial auto installation wizard appears.

2  Setting the OSD language.

Press

 

a/b/c/d 

to select the desired language.

3  Setting the country.

Press

 ▲/▼/◄/► to select your country or area.

This setting screen only appears during the first 
installation.

4  Starting channel search.

  

Press 

▲/▼ to select “Channel tuning” and then 

press OK.

If you want to search for more broadcasts, 

execute “DTV (or ATV) manual tuning” from the 
menu “CHANNEL” (Page 18).

To watch both analogue broadcasts and digital 

broadcasts, you should perform the channel 
search setting “DTV+ATV”.

•

•

•

•

5  Selecting the TV location.

Press

 ◄/► to select where you will use this TV, and 

then press OK.

•HOME: For home.
•STORE:  DYNAMIC mode is predetermined. If the 
“Picture  Mode” is changed, the TV will automatically 
switch back to “DYNAMIC” when there is no signal input 
from the TV or remote control unit for 30 minutes.

If you have chosen “STORE” by mistake, go to “OPTION” 
→ “Restore Factory Default” → OK, and the TV returns 
to the initial screen.

6  The TV searches for, sorts and stores all the 

receivable TV stations according to their settings 
and the connected antenna.

•

To cancel the initial auto installation in progress, press 

.

• 

If you turn the power on the TV after performing step 4, 
initial auto installation wizard does not appear. The auto 
installation function allows you to execute the installation 
again from the “CHANNEL” menu (Page 18).

• 

The initial auto installation wizard will turn off if your leave 
the TV unattended for 30 minutes before searching for 
channels in step 4.

• 

After initial Auto Tuning is completed, the default PIN is 
automatically set to “1234”. To change the PIN setting, 
refer to “LOCK” menu on page 19.

If you install a DVB-T antenna for the first time of relocate 
it, you should adjust the alignment of the antenna to 
receive a good reception while checking the antenna 
setup screen.
1  Press a channel you want to check.
2  Press MENU. “PICTURE” menu will appear.
3  Press ◄/► to select “CHANNEL” menu.
4  Press  ▲/▼  to select “Signal Information” and 

then press OK.

5  Position and align the antenna so that the maximum 

possible values for “Quality” and “Strength” are 
obtained. 

The values of “Quality” and “Signal Strength” indicate when to 
check the appropriate alignment of the antenna.

Home

Store

Is the antenna cable connected?
Is the AC cord plugged in?

E
E