Read Sharp 37GT-25 Service Manual online
9
37GT-25H
1. HOR POS
a) Receive Philips pattern signal.
b) When
a) Receive Philips pattern signal.
b) When
∧
button is pressed, picture moves to the left.
c) When
∨
button is pressed, picture moves to the right.
d) Adjust the horizontal location to obtain picture centering (Fig.1).
•GEOMETRY ADJUSTMENT PROCEDURE
2. VERT POS
a) Receive Philips pattern signal.
b) When
a) Receive Philips pattern signal.
b) When
∧
button is pressed, picture moves up.
c) When
∨
button is pressed, picture moves down.
d) Adjust the vertical location to obtain picture centering (Fig.2).
3. VERT AM
a) Receive Philips pattern signal.
b) When
a) Receive Philips pattern signal.
b) When
∧
button is pressed, vertical size of picture increases.
c) When
∨
button is pressed, vertical size of picture decreases.
d) Adjust the vertical size to obtain picture overscan (Fig.3).
Fig. 2
Fig. 1
3. VERT SLOP
Fig. 4
Fig. 3
•COLOUR ADJUSTMENT PROCEDURES
2. «B-GAIN», «G-GAIN», «R-GAIN»
a) Adjust G2.
b) Tune a white pattern
c) Adjust colour to minimum.
d) Position colourmeter in the center of screen.
e) Using brightness and contrast buttons, select a luminance of
a) Adjust G2.
b) Tune a white pattern
c) Adjust colour to minimum.
d) Position colourmeter in the center of screen.
e) Using brightness and contrast buttons, select a luminance of
≈120 nits.
f) Operate again in Service Mode and select location R-GAIN and B-GAIN
to obtain colour coordinates:
to obtain colour coordinates:
X = 0.290
± 0.015
Y = 0.284
± 0.015
g) Exit Service Mode and check colour coordinates «X» and «Y» at 20 and 120 nits. It may be
necessary to repeat the same procedure or re-adjust the cuts as show the be below one.
necessary to repeat the same procedure or re-adjust the cuts as show the be below one.
NOTE: Locations «R» alter «X» coordinates; «G» alter «Y» coordinates; «B» alter «X» and «Y» coordinates.
1. Y-DLY
a) Receive Philips pattern signal.
b) When
a) Receive Philips pattern signal.
b) When
∧
button is pressed, luma phase delays.
c) When
∨
button is pressed, chroma phase delays.
d) Adjust the chroma-luma delay.
a) Receive Philips pattern signal.
b) When
∧
button is pressed, upper picture scanning decreases and
lower picture scanning increases.
c) When
∨
button is pressed, upper picture scanning increases and
lower picture scanning decreases.
d) Adjust the vertical symmetry to obtain symmetrical scanning between
upper and lower picture (Fig.4).
Click on the first or last page to see other 37GT-25 service manuals if exist.